Viewing all customer Discussions for:

87-187 Sliding Window Roller, 1/2"dia. Flat Brass

The window doesn't not want to slide properly and gets stuck at times. Wanting to replace both sliders to see if that fixes the problem

Early 80s aluminum frame. Do not know manufacture.

to be exact, the channel plastic housing dimensions are 1 1/2" X 3/4". the raised plastic housing dimensions are 1" X 5/8". the roller is 1/2" diameter X 7/32" wide. Please advise. Thank you.

You have been my 'go to' company for all of the fittings in my house, built in 1975. I looked at all of the offerings you have for window rollers, but none seem to be a good match.The roller above is 5/8" high, 7/8" long, and 5/8" wide. The mounting hole goes to the outside of the slot that the ro ... (cont.)

My existing roller is 7/8 or 10/16 inch high and 7/8 or 14/16 wide. Appears 87-182 could be a good fit. Have also considered the 87-187 but there was no note of the height on the dimensions photo. Thanks, RayNo photo with this email.

Hello, This slider / roller assembly is off an aluminum frame window approx 48" wide by 40" high. (sliding portion 24" wide). The other roller is completely destroyed, no rollers around. I'm not sure if the one that I have included pictures of originally had one or two rollers. Description: Heigh ... (cont.)

Looking for replacement window rollers as shown in picture. Base is 3/4" X 1 1/4". the height to the top of the roller is about 5/8". Do you have a matching replacement. Looking for 4. Thanks

Part No. SWR 52

Length 1 1/8 Width 3/4 Height 1/2

The rollers in my windows are similar to part no 87-189, but the channel the sit in is 1/2" wide. Will part 87-189 fit or can you recommend one that will?

Attached are photos of window rollers that I am attempting to identify and order. It has a plastic housing and a brass roller. The windows are probably Jordan or Alenco manufactured in the 1980s. Thanks