Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

WHAT ARE THESE PARTS MADE OF? REPLACEMENTS DON'T SEEM TO FIT PROPERLY, CAN I GLUE THE OLD BRACKET? IF SO I NEED TO KNOW WHAT KIND OF GLUE TO BUY ACCORDING TO THE MATERIAL OF THE PART.

can you send me the dimensions of this bracket please

I need both the left and right sockets. Are they still available? Approx. size 1.5in. x 1.5in.

they are plastic with a knob on the end that pops into a metal clip that is attached to the back of the cabinet. my picture is missing the plastic knob which broke off.

drawer brackets

Need a replacement if available.

Looking for the above in the following measurement 1" 7/16 x2 1/2" inside measurement where the track goes is 1" the slides are around 20 years old including the Rear Drawer Track Socket. I've had a couple break. Any suggestions

Drawer bracket for kitchen cabinets and or bathroom no identifying numbers Cabinets are 15 + years old

I am look for replacement sockets for my cabinet drawers. There is no engraving or cast number on the existing sockets. The slide itself has a stamped part number and logo that I believe is from Amerock but not certain. "Made in USA 565/2225L; 17002-87". If you could please help me with identificati ... (cont.)

Rear mounting brackets for drawer.

searching for replacement bracket a left and right side. Number on part is 471029

G 6600 bracket opening 1 inch x 2 1/4 inch long x 2 1/8" tall large bottom dresser drawer Made by Amish furniture makers G 6600 imprinted on nylon plastic bracket with an R (for right side) Replacement parts? supplier

I'm looking for a merilat drawer plastic piece that is located at the rear of the drawer. It's a plate that has an opening that is 1 x 1 and a 1/2." This piece is just glued on the rear of the drawer and the slider fits into it.

Trying to decide which one I need

Need a replacement part the the part in the picture

I need replacements for these plastic pieces that hold the drawer slides at the back of the drawers. There are no markings on the plastic pieces, but the drawer slides seem to be imprinted "UNIGRASS 6600" (it's difficult to read).Thanks for your help!Nancy

Need two (2) mounting bracket and holder assemblies

Need Grass6600 10 pieces

Good evening, Please let me know if you have this product in stock? I would like to but 16 of them? Thank you

I have an old Merrilat slide, and the socket broke. I don't know if I can just replace the socket, or the whole slide. The slide that attaches to the cabinet is 22-1/2" OAL, and the slide on the drawer is the same. The socket is a bit funky, and I believe it is no longer made. If I need to replace t ... (cont.)