Viewing all customer Discussions for:

32-334 1-1/4" Drawer Slide Spacer

I need a new slider i I think the one that I have that's broken is 1.25"

i hope you can help. I need spacer for my drawers. 1-1/4" deep 1-1/2 height I need four. let me know if you have the part. Thank you, Diane

Brookhaven cabinets. I need the part that goes into the bracket that hold the sliding shelf

The cabinets are made by SieMatic, around 2000 ... 2005. This is a 2-part plastic subassembly used to connect the rail to the cabinet wall. The butterfly-shaped plug is inserted into a channel in the cabinet wall, at the desired height, and then the part is rotated 90 deg. to lock. The rail is then ... (cont.)

the broken piece holds the drawer slide hardware and is mounted at the front inside of cabinet

One of the slide spacers snapped on our Brookhaven side slide drawers and I'd like to replace it but none of the measurements align to what I've seen available. It's 2 inches long, 1 1/4 deep and 3/4 wide. Pictures attached. Any help finding the correct replacement is appreciated. ... (cont.)

My euro screw from my unit is slightly too big. What size can I buy for this item.

Looking for the bracket that holds the metal drawer rails.

Any chance of finding these? Only the plastic part thx

Where can I get these spacers for Drawer Slide used in Brookhaven Cabinets.

We had the plastic side spacers break on our Brookhaven roll out draw. I need to replace two. The item is 1.25 tall from the base. The bottom is two inches long (including the mounting holes) and the square part is .75".

Looking for this plastic bracket

They are the Brookhaven parts. Drawer brackets 1. 150" and shelf holders dia 0.150" can I get them from you? what is p/n? thank you boris

Plastic side bracket is broken. Everything else works.

2'' side spacer

stamped inside the part: G* 6603-920 6

Plastic drawer glide bracket

Need 4 of these items.

Looking for a replacement

Looking for this part