Viewing all customer Discussions for:

21-092 Screw Driver Bottom Pivot

Bifold hardware

1984 29.5 x 78 x 1 1/4 Mirrored bi-fold closet door. 16 CFR 1201

I believe I have a broken bottom pivot pin. The plastic block is ok, but I am having trouble figuring out how this all goes back together. My son said the door came off the pivot, and it looks like the pivot pin is in a plastic sleeve. Perhaps what broke of is the end of the plastic sleeve. I found ... (cont.)

Need the pivot pin assembly at the bottom

Need the bottom pin with spring. Broke while removing. About 15 years old. See photos

I am replacing some parts on two Cox bi-fold doors, their series number 26T. The white screw bottom pivot, your part number 21-092, has broken on two more doors. I replaced one other a couple years ago. I'd also like to replace the brown spring-loaded guide on the lower leading edge of the door b ... (cont.)

Hello, We have a set of bi-fold doors that are scraping the bottom track. I should be able to turn the pivot screw clockwise to raise the doors, however turning the screws does not produce a result. There is a lot of room between the header and the panels. Do you sell the plastic clips or the comp ... (cont.)

This part came off an bi-fold door with a metal frame. It is mirrored. The bushing appears to be missing and allowing the pin to wobble and of course, fall out of the pin holder on the bottom of the floor.

Hi I need more part for mi mirror bifold closet

I need to replace this wheel, I sure hope you can help.

I just ordered a 21-092 pivot and two 23-120 top rollers. I see no reference to bottom rollers. Top rollers had been installed at the bottom but they failed. What should I order?

Dear Customer Care Would it be possible for you to help me find the right parts to fix my bi-fold mirror door made by Independent Mirror Industries Inc? Thank you for any assistance you can provide. Sincerely Lisa

I need to replace this pivot. What block and pivot would I need?

My closet door is not able to close correctly. My handy man says that the bottom left corner block is not working well and the screw is not able to go in and attach properly to the bottom part and therefore the door is not high enough to roll properly on the rail. Do you think that the corner bloc ... (cont.)

Hi , I need to fix very heavy mirrored bi-fold closed doors.Each door is at least 50lb.It is custom made:91"H X 71 1/2"(full open) panels.Problem is that is very difficult to open and close doors ,I tried to adjust bottom pivot but realized that corner block is broken.Look like that doors are to h ... (cont.)

This is top of door. I need bottom block and pivot. The 34-407 shows 1 hole that is 7/16 and mine has 2 holes that are 7/16. Also, will the 21-092 work with 34-407 on the bottom of the door? Does color matter? Mine is a beige cream color.

Hi -- I just moved into an apt and the mirrored closet door doesn't open or close because I think the door is too low and the bottom edge of the door can't get over the track. I tried to adjust the height but it is not working. Would like to get your advice on what parts to replace to make it work ... (cont.)

Mirrored closet door bottom pivot

Adjustable pin assembly for closet door . Pin and plastic holder broke). Fits inside plastic square assembly with SP marked on part. Masonite closet door was supplier brand. Adjustable pin was spring loaded. Please help. Thanks, Dave and Karen B.

Attached are 3 pictures of the piece I need for my closet door. It is a mirrored closet door and the brand is Cox. The piece is 3 inches by 2 inches by 1/2 inch.Also, there is a small marking on it that says Cx. There is no number. Thanks - Michelle