Viewing all customer Discussions for:

32-345 Wrap Around Frame Cabinet Compact Hinge

I need 5 or so of this kitchen cabinet hinge.

My Blum hinge is bent and need to replace it. 110 degrees. Part numbers are34.355-01.0. And 213.21,, 5/16

Looking for this hinge

Need some replacement hinges for grass 860-01 00-11 thanks, Mike

Looking for a cabinet door hinge

Looking for the attached

I am looking for replacement hinges with soft close. I cannot find a match. Thanks for your help in advance.

I am looking for the exact size of 32-343, but I need the hinge to open up completely flat, and I need the screw to install inside the cabinet to be in the center of the hardware, not two screws, just need one in the center.

im looking for grass 830-19 hinges or a replacement that will work

I need a few of these hinges for my cabinets My cabinets were made by ANSI KCMA A161.1-1990 is on one of the labels on my cabinet

I need 4 of these hinges. The IPad photo has a brass color. The scanned immage attached is somewhat off color.

Will this hinge fit an Amerock 5027474 hinge? I can't find yem online, I think they've been discontinued. Thank you

Our hinge has broken. Can you send us two replacement hinges

I am looking for hinge limiters for my DTC hinges with cabinet doors near my walls. I can't identify what model of hinge this is or find the correct hinge limiter for my hinges. Could you please help me?

Hello;I am looking for cabinet door hinges, mounting holes is 1 3/4 center to center, please see photos attached. Thanks,Sonny

I need a pair of replacements for bathroom cabinet door. I see you have one option I'm pretty sure will work and another option I'm not so sure about. Which set should I try? See pic of broken hinge. Thank you

Hi, i am looking for mepla acc 162 kitchen cabinet hinge, 510.356.00.34, 1-5/16" overlay, square top, type-a. I think this is the correct description for the hinge pictured/attached. Thanks.

1 1/2" overlay, for face frame cabinet number on back of Hinge 03030.67

Hi there, I need a replacement for the hinge in my photo. It's Mepla apparently. I was repainting some cabinets and couldn't get one out, tried to lift it with a putty knife and one of the wings broke off. Thanks !

Your site shows several previous searches for this part number. As shown in the fifth photo the center hole for the hinge is 1-3/8" (35 cm) in diameter. The two holes for the screws are 2-1/32" (5.15 cm) apart. The overlay is 1-3/8" These cabinets were installed in 2002.