Viewing all customer Discussions for:

55-196 3' Snap-in Glazing

My vinyl glazing is for a baement window. It measures 0.48" wide at the base. It is 0.3" tall. It has a 0.1" foot at the bottom the vertical edge. It has a 0.03" lip on the sloped side (0.12" from the bottom of the slope)

Looking to replace a lot of this beading! Measuring is not my strong point, however here is what I have on this piece: 7/16 across bottom 1/4 straight side 1/2 slanted side The windows are original to the house, built in 1977; there are not any marking on the window or frames.

Trying to find glazing strips to repair broken window pane in aluminum window. Measurements are 7/16 on flat side, 7/16 across bottom and 5/16 high (including hook) side.

Gray 5/8 by 5/16

Hello, I'm looking for help identifying the right replacement part for this glazing bead. There are no markings on the piece. The house was built in 1989 and I think these are original to the house. Picture attached. the side with the "lips" (shorter side) is 11/32in, the longest side is 33/64in ... (cont.)

Can you tell us what size would be the appropriate replacement? We already tried ourselves and got the wrong size! The frame edge appears to be a hair more than 1/4 inch and the facing about 1/2 inch? Can this be purchased in the New Orleans area or do we need to order? Thank you for your ass ... (cont.)

1/2" tall 5/8" wide

It's close to the capitol snap in, I'm measuring ⅝" vs

Dear Sirs, I'm trying to replace 1 glass pannel of an old aluminum frame window. I'm looking for white vinyl snap, as the ones in the picture. The glass pannel dimensions is 11 x 14 inches. could you please help me identify the product I need. Thanks, Leo

Hi, My husband and I recently purchased and moved into an 18-year-old house in Florida, while cleaning the windows I noticed the snap in glazing on our front windows is either cracked or missing. I would love to replace the existing glazing with new pieces. The first photo is a full picture of one ... (cont.)

Only piece that has not desintegrated 1980 mobile home. Hope enough to identify. 10 windows.

See the image, could not remove the molding in one piece due to it's age. Measures 1/4" tall and 1/2" from left end of molding to vertical support. Lower right tab is approximately 3/32"and upper right tab is approximately 1/32". Small lip on the left side of the molding after radius. Installed ... (cont.)

Please help locate a replacement

Searching for replacement parts for old aluminum single hung windows . Snap in window glazing made of pvc

Hello, I recently purchased a home built in 1966 with a room addition in the 70s. I have many windows where the snap in glazing is damaged. Attached are some photos both on and off the windows. Please help identify a suitable replacement. The part is 1/2" wide, 5/16" tall, with a 1/16" lip. ... (cont.)

trying to locate these (2) strips for my windows

Please, match.

The bead strip on the left is the one I removed and what I need. It is slightly taller than the one on the right. It seems to be slightly taller than 1/4 inch at 9/32 or so. The long leg is 1/2 inch. The one on the right is what I bought from the local Binswanger and it is to short at slightly le ... (cont.)

I am looking for a replacement snap-in glazing for 1990s era ALENCO windows. The profile is a simple quarter-round cross section in white but I cannot match the dimensions. I scanned your site but could not find anything that was a good dimensional match. Any help you could provide in identifyin ... (cont.)

Windows are single pane, house built in 1989