Viewing all customer Discussions for:

55-196 3' Snap-in Glazing

1980's Aluminum window glass frame - single glass pane type. I could not find in your web site the glazing bead of the same cross sectional configuration as shown in the attached pictures. Please help me to find if you have one like this. Thank you. lao tseng

is this item availabe to purchase

I AM TRYING TO FIND THIS TYPE OF BEADING.

Aluminum window single pane snap in glaze Approx 5/16 wide and 1/2 tall. Vinyl?

Window is aluminum but frame is either plastic or vinyl that has hardened and breaking to pieces. The frame holds the glass panels from falling out. Only label on the window is of the one attached in the pictures.

The glazing bead in all of my windows are cracking. Do you carry this product? What would it take to replace? Do I need to hire someone or can I do it on my own. Thank you!

I will be ordering approximately 20 window lifts. In addition, I need to replace brackets, sections of mullions (spelled incorrectly in attachment) and plastic edging that snaps into the mullions. I prefer if the mullion material and plastic edging can be purchased as long pieces that can be cut t ... (cont.)

Swisco Folks:Just spoke to one of your reps and I've uploaded two photos of Milgard Balancers for identifying the proper replacement. that I need a replacement for two of them as springs are rusted.Stamped number is 26-CLength end to end metal (not including white plastic) is 27 inches. I need two ... (cont.)

Hello, I am trying to identify some gray bead for replacement. I think it may be the "Croft" but not sure. I am including pictures of it on the window and off. Thank you, Scott

Trying to locate replacement glazing. These were builder's originals and are 10+ years old. I think they are white. And I hope I got the dimensions correct.

Dear Sirs, See the photo of the old grey window glazing strip I'm trying to replace. Can you identify it? George Cleveland

The dimensions and the strip can be seen in the accompanying photo.

Had 3 Windows break during Hurricane Micheal and want to repair to match the 30 other windows.Can you help?

Probably 20+ years old. Need replacement. No markings.Gray vinyl.

Hello,I need some assistance identifying and also seeing if you carry this Alenco snap-in window glazing material. I drew an illustration of the profile as well in case you had issues seeing it in the actual photos.ThanksJae

Do you carry this vinyl all window trim

I'm trying to locate these two parts. The one on the left is a screen retainer of sorts - 1.5-inches long & snaps into the exterior side of the sash to support or center the screen. The part on the right is a 1/2-inch wide sash guide that is screwed to the frame and clips over the edge of the sash ... (cont.)

Plastic snap-in glazing from original aluminum windows from house built in Denver in 1968. Single glazed; 11" x 11" panes; entire house full of similar windows. No names or markings on gray plastic snap-in glazing pieces; No window brand info. There are two sizes of plastic pieces with cross-sect ... (cont.)

My vinyl glazing is for a baement window. It measures 0.48" wide at the base. It is 0.3" tall. It has a 0.1" foot at the bottom the vertical edge. It has a 0.03" lip on the sloped side (0.12" from the bottom of the slope)

Looking to replace a lot of this beading! Measuring is not my strong point, however here is what I have on this piece: 7/16 across bottom 1/4 straight side 1/2 slanted side The windows are original to the house, built in 1977; there are not any marking on the window or frames.