Viewing all customer Discussions for:

55-196 3' Snap-in Glazing

Looking for this size: 9/32" x 1/2"

(7) windows 29B (1) window 23C

I have a broken part for a window made in 1982 by Kaiserhof Consolidated in Houston,TX. It is a plastic exterior window trim/glazing piece with dimensions noted in the attached picture. Do you have compatible part available?

Looking for a white vinyl glazing bead as in photo.

Do you have something compatible with uploaded pics?

The curved section is 1/2" the straight section is 5/16" Each edge has a small tab measuring approximately 1/8" Need at least 10 3' sections

I am sure you'll help me to find it...

Help!I'm looking for the white snap-in vinyl glazing bead for the original Champion brand windows that were installed in 1984 when home was built. Thank you!Dan

I need white vinyl glazing bead with the following dimensions - approximately 5/16" (horizontal segment) x 9/16" (curved vertical segment) as shown above. 3' lengths would be fine. I need 8 pieces. This is for single hung vinyl windows made by "CA"

I am looking for replacement beading for Anderson windows marked CIG 2 2 90 High Performance WIndows. I need 6 feet of Brown. Looking at the options I dont see this one speficially, which one will work?

Hello, I'm looking to confirm these are silverline windows and order parts for refurbishment. Is this a 39-025 operator? Also, looking to identify the vinyl. 3/4 width. 5/16 height.

Hope this enough information. I have 43 pieces of window glaze that goes around typical window as shown. They are a little over 13" high and 9+" wide. I did not count the vertical/horizontal runs. I am looking to identify the plastic glaze and the amount I should order. This is my second reques ... (cont.)

have a sunset shaped window that is 58" wide and 10" tall at the center looking for vinyl trim that holds the thermal glass in place no name on the window but i know it was made in 1988 when the house was built. White in color and I measured it at 3/8" on the face and 1/4" on the part that goes into ... (cont.)

I would like to purchase this glaze for my 6x6 ft window.

I'm having trouble looking for a window vinyl glazing bead snap in to replace my old one. I cannot figure out which model it is. I've sent a picture of my old vinyl glazing bead and a sketch of the measurements. Thanks and have a nice day.

I need (6) pieces please

I am looking for 2 different styles. The first one is shown in the 2 photos on the left. The flat dimension is 5/8". The second is the 3 photos on the right. The dimension in the far right photo is 3/8". The dimension in the 2nd photo from the right is 9/16". Please note the step down in the mi ... (cont.)

Hello and good day. I was needing some help in tracking down some parts for my Kinro windows. I'm looking for the correct spiral balancers (looks like a tan or brown color), glazing bead, and weatherstripping. I appreciate any help I can get.

Gray vinyl glazing 3/8 x 9/16 is what i measured. would 3/8 x 5/8 work for me ?

A while back you sent me a few samples of snap in glazing. I've been trying these but none are fitting. I've attached pictures of our part compared with your 55-196. The 55-196 is on the left in both. It is a bit too large. The base 9/32" is okay but the width of 5/8" is too large. Ours is closer to ... (cont.)