Viewing all customer Discussions for:

55-196-6 6' Snap-In Glazing

I'm trying to find Replacement Glass & Glazing Bead for a Champion Brand Window. The glass measures 33.5" wide x 28.5" tall. I greatly appreciate any help you can provide. Thanks!

Need assistance finding the correct part to order to replace damaged and missing glazing

Hi, I am looking for Snap-in vinyl for windows circa 1958. I believe that measurements are 7/16 for shorter side and 3/4 for longer side.

The curved section is 1/2" the straight section is 5/16" Each edge has a small tab measuring approximately 1/8" Need at least 10 3' sections

I suppose white beads can be painted over as well. I hope the caliper readings are good enough. If not, kindly let me know if I should add more photos. Thank you.

Window is aluminum but frame is either plastic or vinyl that has hardened and breaking to pieces. The frame holds the glass panels from falling out. Only label on the window is of the one attached in the pictures.

Trying to locate replacement glazing. These were builder's originals and are 10+ years old. I think they are white. And I hope I got the dimensions correct.

Had 3 Windows break during Hurricane Micheal and want to repair to match the 30 other windows.Can you help?

Probably 20+ years old. Need replacement. No markings.Gray vinyl.

Plastic snap-in glazing from original aluminum windows from house built in Denver in 1968. Single glazed; 11" x 11" panes; entire house full of similar windows. No names or markings on gray plastic snap-in glazing pieces; No window brand info. There are two sizes of plastic pieces with cross-sect ... (cont.)

My vinyl glazing is for a baement window. It measures 0.48" wide at the base. It is 0.3" tall. It has a 0.1" foot at the bottom the vertical edge. It has a 0.03" lip on the sloped side (0.12" from the bottom of the slope)

Looking to replace a lot of this beading! Measuring is not my strong point, however here is what I have on this piece: 7/16 across bottom 1/4 straight side 1/2 slanted side The windows are original to the house, built in 1977; there are not any marking on the window or frames.

Gray 5/8 by 5/16

Can you tell us what size would be the appropriate replacement? We already tried ourselves and got the wrong size! The frame edge appears to be a hair more than 1/4 inch and the facing about 1/2 inch? Can this be purchased in the New Orleans area or do we need to order? Thank you for your ass ... (cont.)

See the image, could not remove the molding in one piece due to it's age. Measures 1/4" tall and 1/2" from left end of molding to vertical support. Lower right tab is approximately 3/32"and upper right tab is approximately 1/32". Small lip on the left side of the molding after radius. Installed ... (cont.)

Searching for replacement parts for old aluminum single hung windows . Snap in window glazing made of pvc

Windows are single pane, house built in 1989

Looking for snap-in Glazing very similar to your #55-202 except that the flat part is 9/32 rather than 3/8". Color is Gray.

I made a previous order and what I selected didn't fit. I ordered the gray 55-006-6

THIS MEASURES 1/4 HIGH X 1/2 WIDE. Can you identify by the picture please?