Viewing all customer Discussions for:

32-299 3/4" Shelf Bracket, 1/4" Peg

Back of the clip says 31 PAT'D P.X.IND

The back of pegs reads PX Patened W.Hanover MA Self locking Shelf Support pegs either 5mm or 6 mm for a 3/4 inch shelf

Hello! I can't show you the part I need uninstalled because it's still (barely) holding up the shelf. The cabinets were installed before 1992, and I just noticed that the right side of one shelf is suddenly uneven. Uh-oh! The pegs/brackets are rectangular & white, but I think I'll replace them a ... (cont.)

Hello. I'm trying to find a replacement similar to the above. Do you have anything similar to it? Regards, Monique

Kitchen cabinet shelves clips

PX IND 34 imprinted on back L shaped with shelf projectile on front and 6 1/4 cm diameter projectile on back

Hello Swisco.I am trying to procure four (with extras in case of breakage) cabinet support clips/shelf support for a Haas brand cabinet. The clip would need a 5mm peg size and the shelf itself is 3/4 inch. (The one from Haas came with an end support on some to hold the ledge in place, but not expect ... (cont.)

I'm looking to replace this cabinet shelf clip/peg. I'm having trouble finding a replacement that has a short enough peg. The shelf width is 3/4" and the peg length is between 5-6mm. writing on the clip says: P.X. IND. 34 PATENTED W. HANOVER, MA

I need some shelf clip but the 1/4" peg is too small

10 pieces

The post is only 1/4 inch long the diameter of the peg is 1/4 inch also

Hello,I have a customer who needs replacement shelf clips for the attached.The print reads Jawala Int No.132.The customer just needs something with the correct DEPTH of pin to fit in the existing holes.It does not necessarily need to be a locking clip type support; it could be a straight pin or angl ... (cont.)

There's nothing in the legs to indicate brand or specifics

DTC is the brand listed on the peg. The peg part seems to be 6.9mm in diameter it is 2.75in tall

Hello, I am trying to locate a matching part for my kitchen drawer. Please see photos above. Thanks, Don

hello, says p.x. ind. then the number 22

On the clip it says 8 PAT'D P.X.IND

I have a shelf bracket like part number 32-299. The peg is 3/16 not 1/4. Do you have a 3/16 replacement?

Number 34 on part

Do you have this part for A kitchen shelf? Thanks in advance!