Viewing all customer Discussions for:

32-299 3/4" Shelf Bracket, 1/4" Peg

Hello, I'm looking for a replacement for my kitchen cabinet shelf bracket. My kitchen cabinet is Omega brand and the shelf thickness is 3/4". It looks like your product 32-299 might be the equivalent but I want to confirm. Thanks Ben

Hello! I'm trying to find replacement brackets for my kitchen cabinets and have hit a dead end. My cabinets are circa 1988 and the dowels that go into the holes are slightly larger than the replacement ones I find. The original dowels are also shorter than replacements so new pegs do not fit fully ... (cont.)

Do you all have this cabinet clip

Part say: PX IND 34 Patented W. Hanover , MA

Do you have these? The pin is 3/16

I need some white plastic shelf pins for a kitchen cabinet. The shelf is 3/4", the pin is 5mm in diameter, with the groves and it is a locking one, as you can see in the photos. On the back is printed, "P.X. IND. 34" and below "W. Hanover, MA." The holes, in the cabinet, cannot take a pin bigger tha ... (cont.)

Looking for shelf supports to replace originals marked "P.X. IND. 34 PATENTED W. HANOVER, MA.

Good afternoon, please I need help with this shelf bracket. Thanks and have a nice day

Good morning, Need as least 12 to 24 clips. See attached pics

Hi, I'm looking for some replacement clips that broke to hold up the shelf in my kitchen cabinets. Original part was beige, and marking on back says pat'd p.x.ind. and I tried to upload pics. But I keep getting memory errors.

3/4" Shelf Bracket Product Code: 32-299 Does this have a Round Peg or a Squared-off peg?

The part height is 2.25 inches n less than inch across. The photo backside has broken peg toward lower end. Takes 4 of these clips to hold one shelf in place! Thx!

Hey I am currently lookking for a part like this. I recently ordered a part similar to this one only difference is that the peg is a hexagon and not round like in the picture above..

the bracket has the following written on it. p.x. Ind 34 Patented W Handover MA Is this the one you pictured as the 32-299 for 3/4" shelf bracket

Moved and can't find clips that hold shelves. Nobody seems to carry the correct size. Please help. Claudia

I need several shelf supports that look like your number 32, but mine has a 34 on it. It is 2 1/2 in. Long, 3/4 in wide. I have sent a picture of the front and one of the back.

I need to replace some broken shelf supports in my kitchen cabinets. A few days I purchased some replacements form swisco (part #32-299). Unfortunately, the small dowel part of the support that insert into the shelf holes in the cabinet (follow?) are too small. Do you have the same supports availab ... (cont.)

Hello: I'm trying to find replacements for these 25-year-old plastic shelf clips. On the back of the clip, it reads: "Pat'd P.X. IND." One clip has the number 14, the other has the number 25. Both clips were glued onto a cupboard wall, and came out. Thank you!

Hello. Would like to known what type of shelf bracket this is and if you still make and/or sell it? This was in a kitchen cabinet in a 1985 home so was a little worried I wouldn't be able to find it anymore or something similar to it that would work. Any information would be greatly appreciated. ... (cont.)

Do you carry this part?P.X. IND. 17 PATENTED W. HANOVER MA. (SHELF BRACKET WITH PIN AND CORNER STOP). It is made from plastic