Viewing all customer Discussions for:

55-203 3' Snap-in Glazing Bead

The manufacturer is Atrium Aluminum Products, window series 775. The home was built in 1998, and I need to replace each window's snap-in check rails - the part where the bottom part of the upper sash and the upper part of the lower sash come in contact. I have seventeen 3' wide double hung windows ... (cont.)

There are no visible markings, letters or numbers on any of the windows. The only way to see what the snap in glazing looks like is from the attached photos.

Could you please help us identify this part on my mother

I need some snap-in glazing to repair my windows. The snap-in glazing I need is similar to your 55-172-6 snap-in except my snap-in is 3/8 inches wide at the top and 5/8 inches wide at the bottom versus 5/16 inches and 1/2 inches for the 55-172-6. Can you identify this glazing and is it still a ... (cont.)

Windows I believe to be AAMA series 300/2300. This is the only info I found on the windows. My customer has about 9 windows that need this bead replaced. I have been trying to find a match. Maybe you guys can help me out. Thank you.

Not sure which type this is. Please help! It looks like a 3' Keller snap in but wanted to make sure before I buy.

Windows frame

Hello, Please let me know if you have this part for the windows and in which part of your website I can find it. I need different sizes. Thank you!

Unfortunately I

This came off a Milgard Window. Color: Black Do you have an exact match or something that will work for me? Thanks

This bead appears to be 55-191 however the tail that tucks back into the glass seems to be a little longer. I ordered the correct beads the first time and want to make sure these will fit. Would greatly appreciate your expert opinion. Thanks, Jerry

Could you tell me what part number this beading is please

I cannot find what I need here. Hoping for direction. I am selling my home and so much of the window glazing is brittle/yellow/broken. help! it is 3/8" wide x "a little over" 3/8" high. hopefully the image is seen below steph

I need to replace the snap-in plastic bead on my 1994 windows. I think they were built by Atrium, but I can't be sure. The manufacturer's code is AB-1, series 1200. See attached picture. Thanks.

I had my sealed thermopane windows replaced but the installer broke a couple of the retainer clips - says they aren't available anymore. Do you have anything that would work? In another post you say they are the Keller 2048 series. Thanks in advance, David

Need window bead. Not sure how critical dims are but the 55-203 seems fairly close. Thanks in advance for your help.

No names, no markings

I'm looking to replace some damaged vinyl glazing bead on my windows. They have a Ga on the locking mechanism. I ordered the 55-180 and the biggest side that is exposed is too small at 7/16". As you can see in the measurements I need it to be 9/16". Do you have anything that will work? ... (cont.)

Help need to find glazing bead that is identical, or closest match. So far found some similar but missing the > "fold" that sits underneath glass, have found lots of flat ones. Any help would be appreciated.

I am in need of a glazing strip as image. Looks like its 1/2" x !/2". John