Viewing all customer Discussions for:

22-208 4" Pull Handle

I'm looking for the knobs as I have the handles

are these available for purchase and where

Do you have availability and cost for one please

I need a replacement for this drawer pull. I can't find it anywhere. From the garden terrace collection purchased in 1995. Can i purchase it from you? Thanks, Pam

I need to replace a Thomasville drawer pull like this.

Looking for replacement. Handle has markings A4806-1 with a 1 underneath and H?(sideways 8)ne. Circles have A2603S and H?(sideways 8)ne.

Looking for the following: Drexel Heritage Bali swing dresser pull, part# D0568

B-4592-T 5 CONT-B the only markings.

Looking for a replacement handle for a dresser drawer

Hi I am looking for a replacement handle of this exact handle or handles similar to replace the handles I have on my dresser, chest and nightstand . The size of the side plates would need to be larger than 2 5/8 inches long. The handle itself is 6 3/4 inches across and the vertical holes for the ... (cont.)

The name of the furniture manufacturer is Thomasville. I am needing a new dresser drawer handle like the picture below.

could you tell me if you have 1 pull such as this? I believe its a 4" wide pull... But if you have 2 that are 3" wide I would change one drawer out and have them installed on the top drawer...

I am interested in Seven to Ten Thomasville Villa Soleil hung Handle #40611-131 for my bedroom dresser.Please let know if you can get them or something similar.Thank you,My Name is:Carol

Looking for an antique brass 4 inch handle for a Drexel dresser

This handle is 6 inches wide, including the tip that is missing.

I need to replace the drop bail pulls from my Thomasville bedside chest of drawers. See photo. 2 have broken so far, so I'd like to replace all 8 of them with solid brass. Do you have a close match?

LOOKING FOR A REPLACEMENT HANDLE. Numbers on back CONT.B P-1202-T

My drawer hardware isI breaking and I need to find new ones. The ones on my furniture are pot metal and cannot be repaired. I'm open for suggestions these are a bronze color.

I need one like this

I need a 1" in diameter drawer pull bail in antique brass or English brass finish. I have ordered from you a 202 and 208 pull but the bails on both are too big. The bail is the only piece I need. The ones I ordered were an acceptable design but as stated too big.