Viewing all customer Discussions for:

32-353 Edge Mount Cabinet Compact Hinge

Hi, i am looking for mepla acc 162 kitchen cabinet hinge, 510.356.00.34, 1-5/16" overlay, square top, type-a. I think this is the correct description for the hinge pictured/attached. Thanks.

Hi there, I need a replacement for the hinge in my photo. It's Mepla apparently. I was repainting some cabinets and couldn't get one out, tried to lift it with a putty knife and one of the wings broke off. Thanks !

Hello I need these but the rounded part is on the left hand side not the side connected to the panel.

Part # looks like 38n955 01. But hard to read

Looking for replacement of aristocrat hinge as pictured. Thankyou, Patricia

I need six of these hinges. Can you help?

Looking for suitable replacement for this Amerock 2110E cabinet hinge. I think it might be a 1/4 ol. Thank you.

I have a broken cabinet hinge that is 20+ years old. The information on the original hinge is as follows: stamped MEPLA. Made in West Germany. Numbers on cup that mounts into the cabinet door: 698.254 53.00 numbers on hinge part that attaches door to to cabinet frame 348.253 99.79 Numbers where h ... (cont.)

Looking replacement for Mepla 698 254

I have several broken kitchen cabinet hinges. They are Approx 20 years old. There are three sets of part numbers on the back of each hinge. I have been unsuccessful in finding these. 1) 698.243.59.00 2) 697.043.59.00 3) 511.243.01.92

I'm looking for 4 of the hinges in the photo attached

Good Afternoon, If the hinges described above don't fit, are they returnable?

We need 3 of these hinges. They are 2 and 1/4 inches tall.

Trying to help my father find replacement hinges without changing the millwork.

One of my hinges broke and I would like to replace it and have some extra just in case. I found some numbers on it. W. Germany is stamped in one of the parts. The part that broke has a number 348 253 5176 the other part looks like 698 253 5000. I also can make out the letters Mepla. My house was bui ... (cont.)

Hoping you have it.

Do you have replacements?

I'm looking for a replacement for an Amerock cabinet hinge. I believe it is an AMEROCK 2010-2, 35mm 105 Degree, 7/16" Overlay Cabinet Hinge,06U. I need 27 of them. Can you help me out.

Hello, I'm hoping you can help me. I have a full kitchen in need of these (56 in total). The stamped part number appears to be 03030.67 and the spacing between the two screw mounts is 52mm. If you don't happen to have the same part, do you have anything with the same mount, 52mm or just over 2in ... (cont.)

do you have a Canadian Distributor regards David Hancock