Viewing all customer Discussions for:

32-352B 3/4" Drawer Slide Spacer

The plastic block shown are at the front and back of each slide on each side of the cabinet. Rather than the slides being mounted directly to the cabinet these plastic spacers keep the slides about 3/4" inward allowing the slide to clear a lip at the front of the cabinet. I'd like to purchase severa ... (cont.)

the broken piece holds the drawer slide hardware and is mounted at the front inside of cabinet

I need this part...I beleive the part # is 32-337 (1/2" spacers)? can I order it on your site?

One of the slide spacers snapped on our Brookhaven side slide drawers and I'd like to replace it but none of the measurements align to what I've seen available. It's 2 inches long, 1 1/4 deep and 3/4 wide. Pictures attached. Any help finding the correct replacement is appreciated. ... (cont.)

Do you have this drawer spacer? If so how can I order one

Looking for the bracket that holds the metal drawer rails.

Any chance of finding these? Only the plastic part thx

Where can I get these spacers for Drawer Slide used in Brookhaven Cabinets.

5/15/2025

Plastic side bracket is broken. Everything else works.

2'' side spacer

stamped inside the part: G* 6603-920 6

Plastic drawer glide bracket

Looking for this part

Plastic spacer pictured for kitchen craft. Slide part number should be either 562.490-01b21. Or 2149-1 p160

Looking for these kitchen cabinet rail supports can't find them anywhere. Does anybody know if they're made by another name or can steer me in the right direction? All the ones in my cabinets are broken and the rails are now sitting on the shelf so they're not sliding properly please advise if possi ... (cont.)

I would like to know if you can identify these. Also, If you carry them, Diamond Cabinets installed 2007

Wondering if you can supply 4 of these. They are from Woodmode cabinet slider drawer. Thank you

Need a Replacement rollout drawer hardware standard-off.

Hi there,I'm looking to upgrade the shelves in my pantry to drawers. The two existing drawers have spacers mounting to the slides. Do you have these spacers? I can also use a suggestion on which guides to use as well, the drawers would be 21" deep.Thank you,Tal