We need a handle and strike for this sliding glass lock - or a whole new assembly if that makes sense. We also need 2 whole sets! The only part of this that we have is the one mortise lock that is picture. We need the locks and handles and all the other related parts. Thank you for your help!
Side one : DEC 10
Side 2 : PAT#:6.264.252, PAT#:5.820.170, sticker QC-PASS 2777-00 Made in Taiwan 12/05/10.
Measurements
From top screw hole to bottom screw hole 121/8" or 308mm
Thank you very much
This mortise looks similar to our 82-265, though that doesn't tell us much about the handle set. The 82-265 is compatible with dozens of different kinds. Can you at least show me the spot on the door where the old handle installed? Can you also tell me the distance between the installation hole centers?
That's enormous. The only mortise we have that comes close is our 82-260, but it still falls short. The design is different, too.
We simply don't offer any handle with 12" hole spacing. The largest we have is just a little over 6". I have a feeling your hardware was made specifically by the manufacturer for this door, and you will likely have to contact them directly. I apologize for the inconvenience.
