Viewing all customer Discussions for:

Door & Window

Can you tell me what make this roller is? I think it is a peach tree.

I'm looking for rollers that fit into a CD690 corner, Steel wheel is 29mm,casing is 26mm high and 10.5mm thick,need BULK

Can you identify this window operator and provide price and availability? (2 photos below) I looked through your online catalog but couldn't find an operator where the lower mounting holes were offset. If I missed showing any dimension you need let me know.

Plastic parts

The rollers I need to replace are from a metal sliding glass door. 2- 1/8" long, 1-1/4" high, 5/8" wide. The roller has guides on the side to keep it on track. I think the roller was metal? The housing has dimples on each side to lock it in the door channel.

Where to by hardware to replace metal piece and rollers fior sliding glass shower doors..the screw is a flathead . Top part of metal cracked, that the roller ( Philliphead screw for rollers) is attached to

See attached pics for example. These cranks fit my MW Awning and Casement windows. The hole in the handle appears to be 11/32 and the OD of the shaft spines looks to be about 5/16. I need only a few as some of mine have disappeared.

I am trying to replace some window balances. The stamp on the balance reads 23DS 37 with a small stamp between it that looks like tsb mh. The balance is 24" long and 1/2" wide. I'm not sure what to get and the weight stamp. Worried to get the wrong thing cause the single hung non tilt windows a ... (cont.)

Window tilt pin

Non tilt 1/2 in width and metal bar is 30 in long. Thank you!

This fit the 15-045 pivot shoe I had ordered the 26-361 but it will not work mine has the pin in the middle on the back to fit into hole in the frame

25 3 BT Caldwell

please HELP I need 6 sets of tracks.all my tacks are old and need to be replaced the measurements are 23 inches in length. thank you

I am looking for a match for two (2) Patio Glass Door Double Wheel Roller Assemblies as pictured.

I

I am requesting replacement slide buttons due to the one or both prongs snapping off. The bottom view picture should provide the spacing between the 2 prongs even though 1 prong has snapped off. Please let me know if you required additional information or pictures.

The numbers on the spring is 29 s lv cmc 7 I don't see any other numbers I need a set of two. One for each side of window I have other windows that have issues, but have not taken them apart. When I figure out the part number thing, I'll work on those. Thanks for your help Chuck

We have 10 single hung alum windows with 3/8" tubular spiral balances. The window locks say Jacobson on the window latch. The house was built in 2003 for a couple in their 70's at the time. So I'm guessing the windows are not worn out, as even I find them tough to open. All are loud and almost alway ... (cont.)

I'm trying to locate replacement vinyl glazing bead for several windows Any assistance you can provide would be appreciated. Joe

Windows are approximately 29 years old. Total height is 3/4"