Viewing all customer Discussions for:

Closet

I would appreciate your help identifying a Swissco part to replace a front closet door hangar. 15/16" to 1" wheel. Closet door is 3/4" thick. Thank you.

Can you assist with a replacement pair of ball catches with these measurements? I bought a set from Amazon that indicated the length was 1 1/8 inch but it ends up it is slightly too short.

How do I remove these sliding doors? The track and valance are all one piece so I can't tip the door outwards without bending the valance. Suggestions would be greatly appreciated.

I am searching for replacement hardward for the metal bifold doors shown in the photos.

Do you carry this roller?

We have 5 metal bifold doors that are 98" tall ,our house was built in 1977 do you have replace ment pins and caps . The pins Top are 1/4" x4 and 3/4 long and bottom pins are 1/4" x 5" long. Also do you have a distributor in Canada? Thanks for you help John

sliding glass door bottom guide

Top roller is broken , where I can find it ?

this is the pin that holds the mirrow sliding door in the rail

I'm reaching out regarding an issue with our sliding door. The door has stopped sliding properly, and I've noticed that the pin at the bottom is no longer moving. I'm unsure whether the entire mechanism needs to be replaced or if there are specific spare parts available to replace just the pin. Plea ... (cont.)

Stanley track # 4144I can not get this track anywhere! Any suggestions?

Good morning, Looking to replace the top and bottom tracks (48 inches) for a closet with metal bifold doors. The house was built in the 70s. Please see attached pic of one of the closet doors and please confirm if product # 21-404 will work. Thank you. Jared

Please help identify.

Floor pivot pen

looking for top bracket with nylon ball ( no markings) and hinge with "CDM" stamped on it. Doors weigh approximately 60 lbs. No markings on the door.

I need, I believe barrel Springs, plastic clips, I need plasticcaps I'm missing the rod, plastic holding clips, I definitely need help with this project.

One of my rails has bent I’ve been looking for the same exact rail, but I cannot find it so I googled this and they brought me to you guys. I believe I see one picture but it’s only 3 feet long. The rail I currently have are wanting to get is about 59 1/2 inches long. Do you guys carry t ... (cont.)

I'm looking for this part. It is for the front door of a cabinet I have. Hoping you can help me.

I would love to find replacements. Thanks.

This bracket has a top pivot that goes into another track bracket hole to allow the door to slide