Viewing all customer Discussions for:

Closet

Im looking for this track here in the photos for a 40

Help! The top bracket is broken and I need a replacement. The track is 3/4" wide on the outside and 7/8" from top to bottom. The pivots do not retract. I need the top bracket and the rubber stop at the far end. Can you identify these parts? Photos attached. John

How do you remove and replace the plastic roller clips on the stanley monarch mirror door without breaking them

I have a FULL-VU closet door composed of two bi-panel elements. To repair it I started to document each element: top pivot 5/16" top glide 1/4" bottom pivot 5/16" bottom glide 1/4" A very wise decision as there appeared to be only simple pins and such. Actually each of the four locations, a ... (cont.)

We have mirrored bypass closet doors that have a very rusty track. The track is 47 inches long and 3 1/2 inches wide. We thought about trying to paint the track but figured we'd check to see if it would not be too expensive to replace instead.

some say front rear and other say rear front, please explain

Hello, I hope I identified my part correctly as part 23-099. Is roller in that part replaceable? I have 6 rollers wear out right in the middle. May be installers used wrong tracks - roller runs between 2 aluminum tracks about 1/16" thick. What are correct tracks to use with those rollers? Thanks and ... (cont.)

Thanks for your help i hope you have this part.

I need 4 sets of wheels and 1 or 2 top gliders - it

I am looking for this replacement part. It is 96 inches long. Please let me know if you have this item. Thanks, Earl

I have been looking for a replacement plastic knob that fits on the end of the metal pin into the floor track of these metal bifold doors. It is actually the white piece in the pictures. I need one of those for a different closet door that is of the same style and make. I could not find any markings ... (cont.)

Hi, I need a new pivot block (or whatever you call the part that slides in the bottom rail) for a bifold mirrored closet door. Problem is that the corner block and rail on my door look different than the others I've seen on your website. It's an old Acme 17-4405 corner block, and the spring-load ... (cont.)

The brackets 23-225 and 23-038 that I purchased don

Can you help me find parts for this doir

I have no idea what type of rollers I need here. Southern Florida Condo built in early 80's. Can you help me determine what type of rollers I need for bottom track? Thank you.

Have these old metal bifold doors. I need help obtaining top and bottom pivots if such a thing.looked at YouTube video but as you can see the doors are a little different. Need parts. Thank you Brad

I'm hoping to find a replacement roller guide as shown in my attached photos... can you help me, or direct me to a supplier who can. Sincerely thankful, Dennis

I need a replacement track for an old set of mirror bifold doors. The guide at the bottom of the door measures almost 7/16" wide. The door set is 4' wide. I have included a picture of the bottom guide, the top track, and the label on the door. Contractors Wardrobe only attached the mirror to someone ... (cont.)

Goal: I need parts to install one (1) 24 inch wooden bi-fold door with mirrors attached (at least not yet

Says NO 452 3/4 inch wheel roller?