Viewing all customer Discussions for:

Closet

Mirrored bypass upper roller

Where I can order this part

Hi talented team, wondering if you can assist with an ID and replacement for this robe guide please this is not one we have had before now have in stock from you - hoping you can assist

For the closet door to be close

I need one half inch roller. The one i bought is 7/16 diameter and is sloppy

I had two of these break. The track is still fine. The pictures I sent you were a combination of the one that has a 1/2 inch offset and a 1/4 inch offset. I need the smaller 1/4 inch offset piece. I ordered this years ago from you. thanks

Closet door hanger.

Hello, I'm looking for the missing parts for this door. I think it might just be the missing snugger? Or assembly that holds the pin in the track. There appears to be a spring already in the track, and one half of the door is still attached (fixed in place by a screw it appears). Any help would be a ... (cont.)

Looking for this part or something similar. it goes on top of the mirror closet door to prevent from moving back and forth in the channel.

Hello I recently saw my wheels cracked on my 2 mirror closet sliding doors I believe the model is 21-717 or 21-767 Can anyone reccomend the current sku for this item

Hi, i need two new hangers, and instructions for use. I'll try to forward an email that contains two photos, front and back. The nylon wheel appears to be 1". I think the door was installed in the mid-1970's. The current ones seem a litlle bent. My name is Page. I can't seem to find your email add ... (cont.)

This is the top pivot for a bifold door house was built in 1968 this is a plastic rail Inside diameter is 5/8”. The picture part says Japan. Can you assist. Thanks.

Top roller for lauan hollow-core bifold closet door (maybe as old as 1960) is so worn out I can't even tell what the roller diameter once was. It once had a spring which is now missing. No brand or number markings on door or hardware. The slot in the track is only 1/2" wide and the inside width o ... (cont.)

Most replacement parts do not have the pivot caps. Therefore we can't use the standard replacement pivots. The size of the cap is 1 1/2 x 1 1/8. We will need eight top and four bottom pivots.

Looking for the floating side roller that is a little bigger than the standard size at lowes/home depot. The original pictured is longer and thicker in diameter than the store bought replacement.

I was very pleased to find your website. I have an old 48" set of 4 lovered closet doors that I purchased from Home Depot approximately 35 years ago, however they have discontinued that size as well as parts. The doors themselves are in pretty good shape except for some nicks and scratches. The doo ... (cont.)

i purshased the parts in the picture about 4 years age to repair the drawer slide in my dresser. i cant find the manufacturer anymore but i was hoping you could identify teses parts . so what i need is the steel railing tat works with these "sliders"

Somehow the hardware for one of my entire doors has been misplaced. This includes four parts from the slider side to the hinge side. Upper and lower are all gone.

I cannot distinguish which is the code for obtaining a certain part above my mirror that needs replacing. Notice the white plastic part on top of the mirror is broken which makes the mirror shift down and has trouble closing, if I can get the exact part tha would be great

Can u tell me what i need for this door to replace because it is horrible. Do you have any person who can install ?