Viewing all customer Discussions for:

Closet

Hi! I have a full vu bifold door that I can’t seem to get back on track. The door isn’t sitting high enough so it drags on the bottom and I can’t seem to things aligned. What parts might you recommend to help get this working again?

The wheels broke off

closet doors are approximately 30 years old. Stamped on caster is U.S. Pat. 4850145. I've seen recommendations for item # 23-064. I don't believe this would work. Need support lip at the base of wooden frame requiring two screws. Any help would be greatly appreciated.

would like the correct pins for replacement on the hinge and guids

Any replacement available for this sliding closet door roller?

Do you carry this?

“Bottom track for mirrored bypass closet doors, concave steel roller wheels, track width 2.75 inches (70mm), rail spacing 1.38 inches (35mm), double raised rail.”

Cox 21-717

Picked up eight (four 14 3/4, four 11 3/4) Benchmark bi-fold doors at a salvage yard.They seem to be in excellent condition, aside from one missing spring, I think all the door specific hardware is intact. I need everything else to install the doors in a pair of 108 inch openings. Not sure if this ... (cont.)

I need to replace these tracks. They started to slide up along the sides. This pushes the doors off alignment. What is the best plan of action?

I have 2 bypass door and need 60" track like it show in photos. It has to be 2" wide if you can help me to find this kind track

Bottom of a 1970's era sliding panel door

Please advise your appropriate replacements for: 1. Track which measures 1 5/8 interior and 2 9/16 in just like dimensions of 1 of your mirror tracks, which I forgot number but think it ends in "58". 2. Rollers which say Acme 4011 and appear to ride on the groove but are worn down after 40 years to ... (cont.)

The first photo is the track, second is where the lower roller should be and the last is the upper roller. I need to replace the missing lower roller on 3 mirror doors. The upper has a stamp that says ACME on it. I do not know what the lower roller are supposed to look like as there were missing whe ... (cont.)

I have multiple mirrored bi-fold closet doors in my home. They have different parts but were purchased from the same company. I need the pictured part to properly adjust the height on my closet doors. Can you advise? Thank you, Jeremy

Image 1928 shows identifying label on door. Need 2 each of rubber roller shown in image 1933A & 1934. Image 1930 shows mount for roller shown in 1933A & 1934. Need one wheel cage as shown in image 1931.

Looking for this braket, thanks !

Need floor guide track for sliding glass closet doors

As first priority we would need help of identifyng, the model of target doors additional info the doors are side moving, also one side is mirror. Followingli, we would would like to ask if you have usable top wheels for this door's model?

Dear Swisco, I would like to replace/upgrade all the hardware for my sliding mirrores closet doors. The closest is 46.5x80 inches. Each mirrores door is 78.25x24.5 inches.