Viewing all customer Discussions for:

Closet

Hello, I'm looking to replace this closet door. I need two tracks. The dimensions are noted on the picture.

Do you have these by chance?? Mobile home closet doors bottom guides!?

Hello, Do you have a replacement part for this glass shower door roller? It's 2.25" wide and hard to find. Thank you. Victor

Hi - I need a 47.5" bottom track. Please advise. Thanks

The roller separated from the base and I need to find a replacement. Thank you for your assistance in this matter.Best,Tom

I'm looking for replacement rollers for a pocket door. The outside of the wheels are 1.5" apart. Thank you, Lou

Hello I'm looking for these replacement parts for the top & bottom sliding closet doors. Or any suggestions on alternative replacement parts. The 1st picture is the bottom 2nd picture is the top. Thank You so much for your help.

I have replaced almost all pins in my benchmark steel door and it still doesn't work.

Can you share part numbers and where I could get replacement parts near Anaheim Ca.

Hello, I am looking to buy (4) rollers for a 36 x 78 size screen door. Distance between screws is 2.0 inches. Any help would be apprecaited. Photo attached.

Hi, I'm trying to figure out which check I need for my Mirrror doors

I need a bottom track and replacement hardware for Benchmark Steel Bifold Doors. The first door has an opening of 72" and the second has an opening of 36". Any help is greatly appreciated--thank you!

We were disconnected as person was checking which complete replacement hardware fo .: 5' foot wood bifold doors ,left pair ,door panels are 783/4 " X 14 3/4" ,Track is 29 3/4" X 1 " Which part # is correct ? Does it contain all parts for above specifications FEQuired , including left side (if dif ... (cont.)

Hello, I am looking for replacement parts to replace mirror bifold door hardware. Original parts, as shown in pictures, would be ideal, but I am open to alternatives. As you can see the top pivot is bent. I would greatly appreciate if you can help with identifying part and an advice. Thanks, Oleg ... (cont.)

What size drill bit should be used to pre-drill the hole for receiving this part?

Hello, I need to replace 4 (2 per door) hangers for a closet door. The parts are seem to correspond to the item referenced in the subject lie line (3/4, 1 -3/8). However the parts labeled "Front Rear" and Rear Front" Have different offsets to allow the doors to bypass. I need two of each hangers. ... (cont.)

Hi. I looking for the by also, the track rail for this rollers. My question is what is the part number for replace it. Please let me know

I need 2 bifold door snuggers with 2 3/4" hd springs.

In the picture you see my mirror door with a concave wheel. I had to replace the old track after buying my home and got the pictured track that looks like it has a track that requires convex rollers. According to my attached picture, which convex roller do you have that would be able to replace th ... (cont.)

Need same piece to install on broken side