Viewing all customer Discussions for:

Drawer & Cabinet

looking to identify hinge. 110 degree, I believe, 1/2" overlay, soft close.thanks!Pete

I need three pulls to match the above, 3 1/2 inches on center.

Hi: I am looking for this hinge. I am looking for 16 of these hinge's. Can you assist me?I look forward to your response. Thank You Ruba

Looking for drawer hardware

Hello. I unfortunately don't have an UNinstalled hinge to show. The 3rd and 4th photos is the actual broken one. I used the others for comparison. If you don't have the exact hinge, might you have one that I can replace this one with, even if I were to position higher or lower than the current, (br ... (cont.)

Amerlock 5027474 One part is broken.

I need the same part as the original poster. Attached are pics. It's the beige plastic slide support bracket. I specifically need the right side

need a replacement drawer pull for a Hon Inwood office desk. holes are 4 3/16 centers. Thanks

I have slide measures 1 1/8 inch wide has a lip goes to 3/4 width without lip need plastic rear mounts

I am trying to find a replacement handle for our Stanley bedroom furniture. The designation on the back of the handle is CONT-B, P-4975-T. Can you help? Thank you.

What options do I have in replacing this hinge?

hinge part number: mepla 346.290.03.00/699.299.03.00. do you have anything that will cross reference to this hinge? this has a 2 1/4 inch hole spacing.

Looking to replace a wood mode corner cabinet hinge that says made in west Germany 652.220.50.00 Thanks so much!

The plastic backstop for side drawer glide is broken on bottom of stop. At this time I am unable to remove it. Possible age of glides could be about 32 years old.

I need a top monorail that a plastic drawer insert fits on

2 doors open to the right and one door opens to the left. The markings that I can see is U8A and a logo.

Socket is two piece design. There are no fasteners holding the socket in place-- instead there are 2 pegs on the back of the socket that plug into the rear wall of the cabinet.

CABINET HINGE 26mm 95 DEGREE FULL OVERLAY IS WHAT i NEED. DO YOU HAVE SOMETHING SIMILAR TO THIS.

Hi...I am looking for an Aristokraft wrap around hinge for bathroom vanity. The vanity is probably about 20+ years old. Thanks for any insight.....Wendy