Viewing all customer Discussions for:

Drawer & Cabinet

I need 10 pair of these. The rail measures 7/8 inch by 3/8 inch (outside dimensions). The rail is approximately 2 inches from the cabinet back so if they could be 4-5 inches long that will be great. Otherwise I'll install a shim to meet the back cabinet wall.

Sorry there are no markings on this part. It is in a tract house kitchen from 1978. Kind of surprised it lasted this long ha! Thanks for your help-much appreciated.. Having trouble finding the proper size. Thanks for your help again...

Hi there. Quick question about this part. How deep is the tab that fits into the slot? It looks to be about 3/16 or 1/4 inch, but I'd appreciate if you could provide the precise depth.

Trying to order a part Grass dynamic nt drawer clip Maybe you number 33-336 Don't see how to order it Ca you help me Wil probably need a couple sets Thanks

I need a right rear drawer socket for Quaker Maid. There is a one inch gap in the socket.

One of those brown brackets that hold that front decorative piece on that shelf has broken and I've tried gluing it but it won't hold. Do you sell those brackets?

Middle rail on my dresser. That part's sits in the front as a guide for the drawer.about 1 and 7/8 long and about 1 1/8 wide and 11/16 high.

I cannot locate the white spacers used on the cabinet frame to secure the mounting of the slides

How do I remove the rail from back bracket. if I cant, can I remove the back bracket completely and get a full set to replace?

Trying to locate replacement hinges for Homecrest Cabinets built in 1988. No identifying marks are found on either the original hinges or the replacement hinges.In 2004, I purchased 18 replacement hinges through a local cabinetry shop (from Homecrest, I believe) and the only identification was a pa ... (cont.)

I have a dresser that needs a center mount track. I will need something that is close to the measurements so that the drawer is at the same height as the adjacent drawers. I don't mind shimming or installing something that will work. The guild is 16 3/4" long (as shown on attached pictures) so what ... (cont.)

Looking for this part.

I am looking for a drawer slide for six drawers that is 11" long. I am including a photo of where I would like to install the slides.

Hello, There is no defining marks or numbers but do you have this part?

Hi. I have the Thomasville Irving Park Collection. I am looking for handle replacements. The handles are actually fine, it is the small circular pieces that screw into the wood that loop that holds the handle has snapped. The handles are 3.5 inches screw to screw. Please let me know if you maybe hav ... (cont.)

Plastic - 2 part rear drawer rail kit that has plugs that fit an existing hole in the pressboard backing

I am looking for a right side bracket for my kitchen drawer and where to find. The local hardware stores do not carry.

Cabinet hinges for 34.255-01.01 110 Austria 213 1 1/4 markings E-mail me about parts you have for this item Thank you Mary

These hinges are 30 years old. We would like to replace them with new ones in a brushed nickel color. Notice the curve in them to fit around the cupboards. There are no markings besides the letter A with a circle around it and a number 7 on the flat part of the hinge.

My cabinet slides are rough. The no. UNIGRASS 6600 is stamped on the drawer side. Total length of the slide on the drawer is 22 1/2" 1 " wide, with a small lip under the edge of the drawer. A 3/4" roller is on the back corner. The inside cabinet rails are 23" long and attached to the cabinet fac ... (cont.)