Viewing all customer Discussions for:

Drawer & Cabinet

I just refinished some old cabinet doors and I would like to get new hinges in a chrome, silver or nickel finish. On the hinge there is a patent which is "pat 3,391,420. I have found hinges that are a similar style at Lowe's and Home Depot but the issue is that the three hole part is closer to hin ... (cont.)

The brown one in the picture is the size I need. The white one is the one that I ordered from you guys.

Our kitchen cabinet center slider is broken. It appears this way. The white part is the broken one.

I have a couple of issues with my vanity drawers. First, I have multiple broken Ferrari G023 brackets for drawer slides in a bathroom vanity. Pictures are attached, with tape measure in photos. Based on your site I think the appropriate replacement is 32-018. Post: https://www.swisco.com/discussio ... (cont.)

There are no markings on bracket. The measurements are 2 1/2" x 1 1/4" back plate and a 2 1/2" long attachment with a 1 1/4" x 1/2" opening.

Hole spacing is at 2 1/2". 3 7/8" wide by 2 1/4" in height Marking on back is BPC 3565 Thanks!

Need correct part number for restrictor clip

Need Door Hinge

Hello there, Can you please help me find he right hinges for my kitchen cabinets? I attached some pictures. The space between the 2 holes on the outside is 2 1/8, the plate with the 3 holes for the inside is 1 1/8 wide and 1 1/2 high. The little cut outs/steps are 3/8. Also, one set has #1 on for t ... (cont.)

Ordered the brackets shown the bottom to replace broken ones shown on top. Doesnt

This is from 1980

cabinet hinge has plastic rollrr with spring and is slightly exposed on outside cabinets are about 30 years old redwood quaker made

Need plastic rear drawer hangers for Scheirich cabinets. Cannot locate them in my home town. Cabinets are approximately 30 years old. Purpose for part is to hold the rack that the drawer glides on. Part is approximately 2 1/2 inches long and 1 1/4 inches wide. Not able to send picture right no ... (cont.)

The back braces/brackets for the drawer rail have broken and I am having difficulty finding replacements that are large enough. When I attempt to use the ones I can find in the local stores, the rail keeps popping out. I considered simply replacing the rail to match the bracket size, but the repla ... (cont.)

This is from back of bathroom vanity drawer rail. Can't find a replacement piece anywhere. This one is broken. Help!

I am searching for the same guide,my guide has a 1/2' space between the guides, do you have those in stock?

I need to purchase two sets of these 3 clips (6 total). One clip supports a long side while the other two support corners, with one support having a metal pin to prevent shelf sliding out of place.

I tried to find a drawing with measurements on the 10-057 and had no luck. I have attached a crude drawing of the one I have. It also has a spring sleeve that the part in the drawing slip into. Is this the 10-57. It does have the cross hair design in the bottom

This was the only remaining track roller on a bedroom dresser I purchased recently. The dresser was made in Mexico and bought in the 70's or early 80's. Thank you!

I think the part that is broken on this Brookhaven kitchen cabinet drawer is the drawer spacer. I believe if I can replace the drawer spacers (the plastic piece is broken on all four places on two drawers), then the drawers would work again, but can you see what you think? Is it hard to replace ... (cont.)