Viewing all customer Discussions for:

Drawer & Cabinet

I'm looking to replace this hinge on my bathroom cabinet door. The top hinge is fine. I can't get the bottom hinge to connect to each other. It's 2 1/4 inches in length and 2 1/2 inches wide. in Can you help? Thxs!

We have Schrock cabinets that are approximately 18 years old and the attached part has broken in our pots and pans drawer. Need replacement any color.

Height is 2.5 inches with screw holes 2 inches apart Screw holes 3/4 inches from edge The indentation in cabinet is 1.5 (see photo with wooden hole) The entire doors ings from the left, with door with handle on right The cabinets were installed circa 1997-98

Draw slide is cracked

Drawer glides o approximately 1960's kitchen cabinets. Would you have anything like this?

One of the plastic drawer slide holders that is screwed to the back of the drawer cabinet has broken. The drawer slide has Unigrass 6600 stamped on it. Our house was built in 1999. I need a replacement part just for the part pictured. Thanks, Margaret

i need to replace some drawer rollers for the kitchen drawers. these cabinet and drawer units were installed in the early 60's. so far i have found nothing locally and hope you can help, i have included two photos to show what i am looking for. thanks for your time and assistance in this matter. ... (cont.)

Most of the cabinets in my house have this type of hinge. The base plate that attaches to the cabinet frame keeps breaking. There are no visible markings on any of the hinges that I can see. Any guesses what replacement hinge might work?

Is a something like this available?

Hello, adding another drawer and need a complete set. Any where I can obtain one?

Need a replacement for this hinge. There is one on this site all the numbers match up accept two numbers you have 664.261.53.00. 88 I need 664.261.53.00 92. I need the hinge and mounting plate.This hinge is in a Kraft made lazy Susan corner cabinet.

QueenslandAustralia

Please ignore the duct tape I'm not able to get the dimensions at this time. I thought you might have some thing that could work.

Comes in three parts. A) The main hinge B) the plate that is screwed to the cabinet, and C) the plate that in between that anchors A to B. Part C is what is broken on two of my hinges. Part C has a number on the back: M585 (see above). If i can get that part, great...if not happy to replace the ... (cont.)

Looking for this part.

I need to find drawer parts for a changing table I'm restoring. I can provide photos or measurements whatever is needed. The plastic drawer glides or broke and the metal track the glide slides on. Thank you Glenn

The wood rail itself is 1-3/32" wide by 1/2" tall while the narrowest width is 11/16". Do you sell this or know where to get it? I moved and 3 broke in 2 dressers.

I am looking for Kitchen Cabinet Door Hinges I need to identify the type they are

Hi, Your 32-076 looks like the drawer slides I have but mine has the small wheel in the center and yours does not. Do you have one with the wheel or do you sell the wheels to go along with this part? Regards, Chris

Stamped 674.205.70.00 on the door side and 592.393.85.00 on the cabinet side. It says "Mepla match" on the inside