Viewing all customer Discussions for:

Drawer & Cabinet

I need a replacement Blum hinge 70.550-01 10 made in Austria. I know it seems like they don't make it anymore. Looking for the replacement hinge?

I would like to know if you have this part/s, Thank you!

The only markings seen are Unigrass 6600 One of these on the drawer is bent near the roller and needs replacing

for cabinet made by Scherich. May be part number 230

Looking for a couple of the following hardware For kitchen repair Door hinges Model 201M soft closure kitchen door hinge Base plate stamped 02 Hinge part stamped 201M Thanks

Is 32-119 the correct replacement part posted.

I need the plastic pieces that the drawers slide into. Anything that might fit? If not what can I do?

I need 8 guide support's we live in a older mobile home and I can't find anything close online

The current broken piece is "Ronthor Reid's Corp. #R-40-28. It is a drawer guide found at the rear bottom of the drawer. I did not see a corresponding number listed.

Looking to replace metal drawer slides and round wooden pieces. Thank you

Looking for these kitchen cabinet hinges in soft close. Markings on the old hinge in pictures are (DTC) and (TH45).

The front drawer panel has fallen off.

Hi, I am looking for the mounting plate for a DTC C80A605 It has to be 3/4 deep

Kitchen drawer

Hello. I need to get four of these. 2 R and 2 L. Its 1 3/4 inch wide channel. Thanks

Need to replace at least 10 of my Kitchen Cabinet MEPLA Hinges

Looking for replacement bracket for this piece. G600 is visible on the piece.

Hi,I have a cabinet drawer rail from 1985. There are not markings listed. The rail it sits on is 22.5 inches from the very back to the very front. The top part that rolls across it is 21 inches. It sits very flat to the cabinet around it (not much spare room is needed around the drawer for it to sli ... (cont.)

Hello. I'm in need of a Ferrari G026 drawer bracket left side as seen in the enclosed photos. The dimensions are 4 1/2" long, 1 7/8" wide, with a stop at 3 5/8" from the back of the cabinet. The guide is 3/8". Thank you for your assistance. Ray

Good afternoon, We are looking for replacement drawer slides for the attached pictures. The one glide shows #PMI-CM565L. Are you able to quote?