Viewing all customer Discussions for:

Drawer & Cabinet

The attached photos are hinges for MEPLA 512.265 and 669.299, which seem to be not available any more. Do you have a substitute for this hardware? I need one unit to replace one that has been damaged. Best, Vic

These hinges have a 1/2" overlay on the cabinet. No name or #s on them

Seeing if you carry or have access to this type of DTC hinge. Need 6 of them.

I have a left side 21 5/8" X 1" under drawer mounted beige colored guide that has a bent rivet and wheel that I need to replace. Which set should I get? The 6600 model 32-061 is what looks to be the one. Is that correct? Please let me know. Campbell

Hello I've looked everywhere however hopefully I found the correct place. My son was leaning on our kitchen drawer and snapped the plastic piece that screws right into the track. Does this look like something that matches your part? Thank you!

Hello I'm looking for this track holder

Trying to find this cabinet door hardware or suitable replacement for all my existing kitchen cabinet doors . Blum with #120

Hope you can help, we need both lengths drawer glides 17-3/4 & 20-3/4. 4 sets of each. also need 8- 1" plastic spacers to hold glides at correct width

3.25" o.c. Drop Handle Drawer pull

I just need this back plate

See pix attached. Darren

Thank you.

black strip which goes in slide part it has metal balls on a strip which goes on top and bottom approximately 7 inches long with 4 balls I need two because one goes on the top and 1 on the bottom I am looking for these two strips to replace I am sending a picture of the part needed thanks ... (cont.)

Hello, I need installation instructions for part 32-223 and I also need to know what type of fastener part 32-223 uses to install. Thank you

looking for 4 each Mepla hinge 510 356 0032 in a Slow Close. Are these available/ Please advise and if so how much are they?

Can I get a soft close/dampening attachment for what I think is a 32-345 (Wrap Around Frame Cabinet Compact Hinge) See picture to confirm hinge type/model #. If not, do you sell separate soft closers/dampeners? If what is the model number/ link? Thanks.

Back wall socket plate broke at screw point from overloaded drawer. Estimate contractor installation was approx 15 years ago.See pics below for socket needed to replace. Slider lips both turn in same direction (downward). No space above or below in current plate. My calcs indicate slider width is ... (cont.)

Does the low profile full extension slides work?

Hi there. Updating a very well built mid century desk and hope to replace all the ball bearing slides. Photos are os the smaller drawers just to see if you can help. The larger ones (not shown) all say Grant. I know they are from the 70's-80's era. The desk was built around only having limi ... (cont.)

Part say: PX IND 34 Patented W. Hanover , MA