Viewing all customer Discussions for:

Lavatory

I need the attached part for bathtub sliding doors.

What material are these chrome finish pulls made of?

The door wiper( I think that's what its called) on our maxx shower roted out. I do not know any part number for the shower other than it's made by Maxx. I sent pitchers of the whole shower and the slot the door wiper or seal goes into. The slot for the wiper is 1/4" x 67"

This part was probably original to the house built in 75.

I'm looking for the parts in the pictures, the rollers in the guides.

Hello Customer service Lenght of my shower bottom (4 screw holes) door drip rail is 32 inch Do i order 36 inch and cut as needed or you also have a 30 inch ? Please confirm drip rail and vinyl sweep seal come's in a set Thank you for your time

Hi I'm looking for shower door bottom sweep for sterling neo angle shower. Model number is worn off, channel on door bottom 5/16 width, sweep at thickest width approx. 7/16" narrow top portion approx 3/8" I have added pic thanks pat

I need to replace these glides. I saw your product code 10-216. Will that work? Do I need special tools to put new ones in?

Hello helpful and wise ones - I've attached two photos of our very old shower door. I think we need to simply get an appropriate door sweep and somehow affix it in the proper position. I'll go in and scrape and clean the metal as best I can but then what do you recommend to affix the door sweep to ... (cont.)

The shower door in the master bathroom is 20 years old and the plastic strip is cracked and broken. I need a replacement strip. The door and strip are 28" wide, but wider is okay if it can be cut. The first picture is an identical door in a guest bathroom that is not used much. The strip shown In th ... (cont.)

I need a new sweep. Door has a frame, 24 inch door. The sweep hooks onto the metal edge. Hopefully this shows up. Any ideas?

I only see chrome and black as options for the 10-325 drip rail. Is there any way I can get a white one?

Hi looking for bottom guide 3 x 1 3/4 x 7/8 with 1/4'' track and bumper 1 5/8 x 5/8 x 1 for Keystone shower doors. Measurements in inches. Thanks

Used with 2830 channel balances

Hello,Unfortunately, we do not carry an exact replacement for your current sweep but consider using our 10-325 sweep and drip rail. It is 30" long, so you may need to cut it down a bit to fit your door. Thank you!

No sure if all I need is the rubber piece or all the sweeper, it mesures about 24 3/4 in long, the metal part looks fine , only about 2 yrs old. Please advise. Thank you

Where can I find a replacement? I submitted a few minutes ago and received ID # d164132 but I had an incorrect e-mail address on the request.

My question is about Swisco product code #10 136 2 1/4? brass handles. Do these come in different sizes too. I think I need 2? one. Can you please help me.. Thank you

This glide is broken on the inside. The hole for the screw is near the center

Broken roller (as pictured, the bracket is OK). I've found 3/4" but these are 1". Also as pictured, the area where the screw goes in is raised out 1/8" where the replacements I'm finding are flat.