Viewing all customer Discussions for:

Other

THE COIL BALANCE PIECES ( BOTH ) IN PHOTO ( FRONT) # 1 AND (BACK ) # 4 ARE 1.25 INCHES WIDE THE WINDOW HAS NO BRAND NAME ON IT- PHOTO # 2 - DOUBLE HUNG VINYL CLAD. THE COIL HAS PRINTED ON IT # 7.5 - 31 " THE TOP PLASTIC PIECE PHOTO # 1 WHICH HOLDS THE COIL HAS PRINTED ON IT - PATENTS 5.232.208, 5.36 ... (cont.)

Hi, I am a new home owner and inherited some DIY work to do on one of the windows in our sunroom. I have done some research and identified the windows as Silverline brand, I believe the one with the issue is part of a Triple Single-Hung assembly possibly from their V1 series (series 2903/4903). The ... (cont.)

This is for our house in Hawaii, I believe is is called a breaker. This is what the latch rides up over it give a tight seal when the window is closed and latched. I will need 10 of these.

1 1/4" wide

I need a template for mortised handle set 41598

Lever to lock door broke

I need help finding these part for a Simonton window

This is on the receiving end of the sliding window. It stops it from slamming and almost help push it and secure it better into the seal. It's a plastic piece about 5/8 in size. I know these windows are from the 1989 range and probably don't have these pieces available but if there is somewhere to o ... (cont.)

I am looking for the following window lock hardware for a crank out window.

Need part info for casement crank assembly (for a casement hinged right looking from the outside). It's silver in colour and attaches to the sash with 3 screws.

The photos indicate what I removed. It is old and brittle. The groove in the metal is .708MM at the front and then much wider inside [do not know what the width is unfortuantely]. I tired using some 1/4 inch foam backer rod from my paint store, and while it fit nicely, it was not stiff enough to ... (cont.)

Looking for this part x 6

I need to find a Truth arm to replace the one that lost the piece that connects it to the window. Right now my tenant cannot use the handle to open and close the window because the arm is no longer attached to the window frame. The photo that I uploaded shows an arm from one of the other windows tha ... (cont.)

Hi I think I have narrowed it down but would appreciate your confirmation Pleas see photos of one of the damaged guides Thanks much

Hi. I need replacement rollers for my (two) sliding screen doors. The existing rollers are metal with an aluminum casing. The wheel diameter is 1 7/16". The casing is 1 9/16" wide and 1 15/16" tall. I needed to drill out the screws securing them to the frame. I see no markings on the frame(s) or rol ... (cont.)

I need lock

Hi, I'm looking for this pivot pin. It is for an Alside double hung vinyl window maufactured around 2014. Thanks! Ron

Do you know the name of these lock sand where I can purchase

i already ordered Top Sash Guide 18-033 which modle i need a 16 in and a 18 in

I am looking for a replacement insert lock for my very old door.