Viewing all customer Discussions for:

Other

I can't find the exact same looking part on your website.

I had these casement windows installed some time ago. At least one of the Cranks is gone where it doesn't close by just turning the knob. I believe a replacement with alleviate the problem. Do you have replacements in stock. Thanks you

As the picture shows, the marking says 26 3. I need both sides.

I hope you can help me with this. The springs are broken on both sides there is a marking 3010 on each spring. It looks like they come all in one unit for each side. I have 10 Certainteed windows in my house, this one I put in in 1999

I'm also looking for replacement for Pella 9040041 window lock

I am looking for removal and installation instruction for window balancer 3660 for a Peachtree window. Any help would greatly appreciated>

need RH casement hinges, with other parts that may be needed with this, as well as mounting hardware (in SS if possible)

Looking for a replacement pivot pin for our window.

I have a set of Pella Doors which need their wool weather stripping replaced. Found the order# 01G8000-DS SC/DS SF Screen Weatherstrip (1992-2004) through the Pella Dealer. The stipping is 1/2in tall in full from bottom to the top including the plastic that goes into the wood. The plastic on the bot ... (cont.)

Need to replace two balances on window. Thanks

Do you have a match for the cabinet hinge in this photo?It has "27" on the lower left. Thank you,Michael

Looking for a key lock cylinder

Hi, I am looking for a replacemnet for a Biltbest ste. gen L62I found a picture on the internet that matches and I attached it .Thank you,Cindy

Looking for a Casement Bottom Hinge Assembly, that a customer threw away. I have the corresponding Top hinge. The stainless track has the number 40941 stamped along with the words "PRY TO REMOVE SASH" and an arrow pointing to the pivot. The Sash arm is painted Beige with the number "31133C" stamp ... (cont.)

Generic window. Do not know manufacture. Single mounting screw. 2 3/4" long. 3/4" wide. Slides in within a channel. Purchased window 20 years ago

Looking to replace the window crank and track on the photos attached. Thank you Neva

Here is some more information that I can share: the push arm, has a number of 40754 stamped on it. The link arm number appears to be 30810, but is XXX'd out, replaced with a new number of 21135. Pull arm has 31538a stamped on it. Hope this is helpful.

Looking for window vent latch with orange dot like the one in the pic...

I need both the top and bottom of these guide arm studs and maybe the guide arms themselves The part that goes on the window frame is bent as well as the clip part This the window gets stuck and doesn't open /close properly

I have a broken casement window operator. It says Entry Guard Truth. The number on the arm is 20544. The number on the cylinder barrel is 30710. The short arm is 3 15/16" center to center of the holes. The outer mounting screw holes are 4 7/16". Looking to replace this.