Viewing all customer Discussions for:

Other

sliding door handle ? I can send a picture

Price please for two these. non tilting, 1/2 inch wide

I have Insul-sash windows. The window will fall down if opened. the rod is 29 inches long Please advise as I have 19 windows to repair. Thanks, Sue C

The tilt locks deteriorated from the sun. Need more

im looking for the part that the coil spring is attached to. it was easy to remove. one screw and it came out. I need left and right side. part # is (H65 32/3M). I don't see it in any of the pictures.. its not the pivot shoe. and it is showing to springs, witch one would match the part # I gave you. ... (cont.)

I have 31inch (glass size) Hurd awning window.The operator (is about 5inch wide encased in the sash) is broken. Can I replace the operator with a new swissco operator (including replacing the guide bar)? thanks...

Does this spline work with Anderson screen doors?

Need two plastic strips that are in vertical portion of vertical frame and hides spring that controls up/down movement.

Door handle hardware replacement Cole Sewell Registration # 03099894821 52 The screws and anchor points internal to the door handle mechanism have snapped in half. Just looking for a part number/s for inside/outside full door handle hardware replacement. Thanks in advance.

1 have a 1989 Anderson screen doo. it needs the top and bottom rollers

Hi I need 4 sach balancers for Anderson windows. These are numbers stamped on the balancer. 11600-3 BP 12#31 6-85 Please advise what I need to order. Thank you.

Looking for top slider shower door bracket -- m 6053

Wheel truck is broken. I have one that is intact. If I send it to you, do you think you can duplicate it?? I cannot find it in any hardware store around. It is approx. 40 years old.

Good Morning Sirs, we are looking for a Replacement Stainless Steel Sliding door Rollers . Please advise if you all carry something similar in Stainless steel .

looking for door sweep for a Cole Sewell storm door. # 010903948022483 Thank you Steve

I have some Marvin tilt out windows manufactured before November 2003... The only identifier I can find is this...IGCC@CBA IGMAC... I'd like to replace the tilt out shoe on some of these windows... Suggestions? Thanks....

Vinyl glazing stops Jeld-Wen sliding patio door

Spring pulley for window

I just bought spring covers and tried to replace them. I found some pivot shoes in bad condition. The part number is 5,704, 165. Could you let me know what product is the real part to replace them?

Good Morning, Can not find any information on the windows but was installed in house in 1999 and I have replaced a few about 10 years ago. The only information that I can find is inside the window "Malta 7B 1". I have taken pictures and the size is: 54 5/16" long end, 53 1/2" short end, W 3 1/2" tw ... (cont.)