Viewing all customer Discussions for:

Other

Can someone help with which balancer this is?

The coil support have "3/8 dual" written on the inside. They don't look broken. I believe the coils broke. They have #6.0 35 Printed on them. I don't know if I should buy coils only and figure out how to assemble them with the support and the pivot shoe, or if I should buy all these pre-assembled a ... (cont.)

Hi, I just bought the house and discovered some window problems. I don't know the window brand, but I suspect Ashland. The spiral balance does not appear to follow standards: it is 35" long, the tip is faded but I think it's yellow, but the diameter is 53/128 (almost 7/16"). I cannot remove the s ... (cont.)

I am not sure if I should be ordering the 380 or 385 series. The length is 28" and width is 1/2". The stamp is 27 C.

This is a left tilt latach off of a Stanley vinly window. This tilt latch snaps in from the top of the sash. Thank you Jordan

This is for the lower sash. I need both left and right.

BF Rich double hung vinyl window. Installed in 1999. Sash weighs 16.6 lbs. pictures of balance provided.

Does this style come in 2 5/16"?

I need both tilt latches , left and right side for Stanley Windows.

Hi Do you have one set of these balances available?

I am in need of the rear drawer socket for a Merillat Silverware Drawer Cabinet. I have included pictures.

I recently ordered 6 replacement pivot bars item # 26-353. They are approximately 1/4 inch too long. Do you carry 3 inch pivot replacement bars? Thanks for trying to help me out. Attached are a few more photos of the bars. The original is on the right side. Thank you for your assistance. ... (cont.)

Ever see pivot bars like this? I need a pair. Thanks

I am looking to buy 2 Ramtrack bottom glides for a sliding mirror door part # 10123. It is the kind that has a plastic piece that you push down into the track and it snaps into the track. They need to fit on the left side of the door at the back(maybe that's obvious)...... Tom

sash weight is 13.4lbs which springs should I use

Weatherstripping bubble seal brand is Noradex inc sending picture

corner clips are used to secure door from openig

I recently just purchased this home and it has this sliding door which slides very nicely and is in good condition but the sliding door’s top rail is sitting freely inside the channel with nothing holding it tight laterally. Can you tell me what is missing from holding it centered? I've been t ... (cont.)

I need four of these. They measure 1-1/8 x 6/8 on the top and are 2" long. Please provide part number

I believe I need to get the 9-15 lb. balance but want to confirm before ordering. Please help!