Viewing all customer Discussions for:

Other

There's a stamp "29 5 LW CMC". Metal channel length is 30". Width is 1/2". I tried my best to get an accurate measurement of the bottom shoe and it appears to be 1-3/32" but hard to be certain. Hope I provided enough details. Thanks in advance

Hi, Please help identify the correct replacement to buy. I don't know the window's brand. It's at least a 30 years old window that came with the house when I bought it. Thank you, bVen

This is part from am old kitchen cabinet drawer.

Screw holes 5-3/4" 1-1/2" tall 6" overall

Hello, I am looking for help to find the correct replacement parts for the parts attached in the photos. For your reference the tie bar guide is stamped 40726. The keeper is stamped 40725. I believe these might be Maxim parts..?

Have one that is broken and need to replace. It has. Two holes 3 1/2 inches center.

The pictures were of drawer stops that were at the top back of the drawers and were stapled into a cut-out in the back of the drawer. When I removed the drawers to move the dresser several of them broke.

Milgard window, 27 inch balance. The balance says "26 4 AW CMC 2"

The window will go up but falls down. The window can tilt in but falls off its track due to this broken piece.

Please see pictures, it looks like a 3/8" width double coil spring setup

the Balance metal only is 27" long

Not sure which part to order looking to get a set of this for my window this is what was removed when trying to figure it out.

The metal cgannel neasure 30 inches but there is a hard-to-read stamp on the metal 29-2

Size 72x78

I have a casement window that needs crank handle replaced. The window manufacturer is CertainTeed. Would your Product Code: 39-205 Truth Folding Crank Handle, 11/32" fit? thanks BK

Harcar window vent lock - need 5 sets, L and R

This is the only stamp on the hardware.

I am trying to find a replacement for this handcrank.

I have quite a few of these 8' sliding doors and each door has 2 rollers. I'm guessing they all need to be replaced. Probably 16 doors total. 32 rollers. I'll get an exact count next time I'm there. I'm the homeowner, also an architect and contractor.

Please help identify the proper part I need for replacement based on provided pics