Viewing all customer Discussions for:

Weatherization

Please see photos. Any help would be greatly appreciated.

I have all 2006/2007 MW double hung vinyl windows across the house I'd like to replace the weatherstripping. The t-bulb is foam filled for the bottom, top and middle of sashes. Then, the rest is a t slot felt.

This part is from a typical sliding door to keep insects out.

I'm having some trouble finding the right size weatherstripping for the gap between my double doors. I ordered your part number 58-045 but the backing strip is too wide. I measured the original strip and it is approximately .15 inches using a caliper or 3.9 mm and the length of the pile isn't cr ... (cont.)

Any Ideas or recomendations? Thank you, Andy

I think I have the Rollyson Double Glazed Windows. All the windows (10) 50" are missing the bottom weather stripping (or just deteriorated from the Southwest Florida weather). Looking for new weather stripping. Thanks Terry

?

I purchased 2020 awning vinyl Windowmaster windows from Home Depot several years ago. The weatherstrip has become bittle from the sun. Have been told Jeld Wen now owns them. Csn you suggest a t-slot weatherstrip? Thank you

The inside wear/seal strip of my Vetter sliding glass door has weathered and cracked. Vetter is no longer in business. Do you have a replacement? The inside door channel the strip is pressed into is about 1/16" wide and 3/16" deep. Please see attached photos. Thank you, Jim Schroeder ... (cont.)

Purchase replacement weather stripping for kolbe external double hung doors

can you help identify this type of weather stripping and an order number, length and cost.

The insulation I am attempting to replace has a 3/16" surface which slides into to groove in the window. This 3/16" surface is approximately 1/32" in thickness. Extending from this surface, and centered within it is an approximate 1/8" by 1/8" area with a radius which meets the outer surface of the ... (cont.)

believe parts worn out and rubber gasket need replaced? do you still have parts for this door?

The width of the backing is 1/4 inch and the brush is between 3/8 and 1/2 inch wide.please identify for purchase

Please help us identify this window rubber...it's very common for the windows especially storm windows that we repair.

Hello, I am trying to identify the correct replacement weather strip along the bottom portion of my vinyl windows. If you could provide some assistance, it would be greatly appreciated. I have 22 windows and they all look the same (need to be replaced). So I would like to order them in longer le ... (cont.)

I am looking for a replacement door sweep for my Larson storm door. It is a 36" door and I am unable to find one with the correct profile. I have enclosed a photo of the slot for the sweep. Please send me your recommendation. Thanks, Wayne

Need a replacement window seal for a 30 yr old Pella model 806 cc window Thanks

The strip I am looking to replace is like a vertical sweep that goes into a sliding screen window. At the bottom edge of the piece in the picture where you see my hand, there is a wedge like thing with a hole in it, about a quarter of an inch from left to right, the presses into a channel in the s ... (cont.)

I'm having a hard time finding this simple extrusion from some older aluminum windows. It's an offset "T" with the post of the "T" off to one side. The top of the "T" is 1/4 wide, and the post is 3/16 tall. The length is 58 inches. I'm guessing it's vinyl. Any help would be awesome. Thanks, Kevi ... (cont.)