Viewing all customer Discussions for:

Weatherization

One inch thick, double brush vertical wearher strips. Aluminum is 1 inch commercial door. Can you get just the brush or both pieces? Andrea

Hello, trying to figure out what type of replacement weather stripping I should replace this with. It has like a center divider in it. Thanks! Measurements in pictures.

Do you guys have angthing like this black rubber type of glazing height is about 11/16 but could be longer by a bit if need be. total width is about 7/16 and the part that presses into the channel is about 5/16 wide and between 3/16 to 1/4 deep thanks in advance for your help

I have a custom bilt storm door fly from Lowe's. The bottom seal is worn T-shaped the top part that goes into the door track is 3/8 inches long and the seal part is 1/2 inch long

Hello, I'm looking for something that goes in the track of the windows because the cold air comes right up those side tracks . My windows go up and down and the bottom tilts out or removes for washing. .

I don't see any identifiers on the door to tell you what brand of door this is but the hinges have Lawrence USA on them.

Hi there, and Happy Holidays. I'm looking for a replacement bottom seal for my windows. I believe these are single hung windows (pic of full window attached). I searched everywhere on the window for the make/model, but I couldn't find any identifying markings. I have included two pics of the windows ... (cont.)

Hi, can you help me match this bottom weather seal? The tube is 3/8" diameter. My tilt windows don't have a brand on them but other parts match what you call Keller. Thanks, Paul

I want to replace my window channel seal. The seal has a 0.25" wide flange for sliding into the window groove. The height of the seal is difficult to measure as it has taken a set but is approximarely 0.25". The seal fits a 24" wide window. Pictures are attached.

hello i am in need some snap in glazing I'm sending you these pictures so hopefully you can identify what particular glazing i need maybe you have this type or something that will work in its place it is 3/8 wide I'm not sure of the measurement of the part that goes into the grove in the wi ... (cont.)

Vintage 1989 casements. Brand unknownspline is .25, bulb diameter is .25 as wellDepth of the kerf is .260 Weatherstrip is in the frame, not the sash Thanks

I don't see the seals on your site. Could you assist and let me know if you have them? They are rubber. Look like 1/4? they are on the bottom of a certainteed window. There are no serial or part numbers on the windows themselves.

Could not find any information on the windows.

Trying to find the weatherstripping that is pressed into the bottom of the lower vinyl window.

Hi and thanks for helping. The weatherstripping channel is 5/16" wide and the pile should be 3/8" high. I didn't see anything on your online catalog with those dimensions. Hope you have something! Thanks, Paul

Since there is no opening, I think I will have to cut and remove small portions of plastic so that the strip can slide out of the sash frame. Is it normal to see door and window makers not leave any cuts to allow the sliding out of wool-pile weatherstripping? I found this on the web and much appreci ... (cont.)

Not exactly sure what window brand I have. I have the AAMA cert attached. Need to identify bubble seal replacement

Need a pair of these door bottom seals. 32" door. Only 1/4" clearance

The whole house has dried out weather stripping on casement windows throughout

I am trying to find a substitute for these two types of weather stripping for our Milgard Tuscany style windows purchased in 2009. Milgard no longer makes this weather stripping. Thank you.