Viewing all customer Discussions for:

Weatherization

Hi, appears to be 1/4 by 1/4 ? Would like white again 2nd part slid out from where top and bottom window meet? Windows built around 97 if that helps. Thanks.

This weatherstripping is from windows that were installed in the late 90s

Sliding glass doors have in the upper left hand corner, Andersen, Class CBA, C7-82SG, and on the sliding door, (of two) there is: PS11 8R. From research, they were made in 1982, and the weather stripping to close the gap needs replacement.Can you help?Many thanks!

I need help

I have 1978ish Pella casement windows. The weatherstripping is 90 degrees L-shaped, about half an inch on the part that goes into the frame (1/4 inch going into the frame and 1/4" of rubber off the frame), and the rubber is about 5/8" wide. I need at least 100'. I can not see any serial numbers or m ... (cont.)

I'm hoping you can help me find replacement weatherstripping for the bottom of my vinyl windows and pile weatherstripping as well. I measured the T and it's 3/16ths and I think I know the product I should order but am also curious what the seals are made of. I live in Wisconsin so the temperatures ... (cont.)

I need a Kerf mount v seal for pella sliding glass door.

Dear Customer Service Department, Do you have a similar weatherseal? Thank you, Mark

Looking for a replacement weather stripping on a window. Any help would be appreciated.

I am in need of 2 weatherstrips for a Lee Haven door from the 1980s. Both are 36" x 80". Both doors have the bottom stripping worn away. The doors are in good shape and hate to replace. Any help would be greatly appreciated.

I have existing pella french doors that need new weather stripping. I have contacted Pella and they said to look for etching in the glass to get the model number. Unfortunately, I'm un able to read any of the etching. These are older wood French doors (I'm assuming) as we bought the house a few y ... (cont.)

uploaded 2 pics i can pull the rubber if need be. but could find anything close. if have to can remove door an buy whole new sweep but this is a double rubber. appears to be 3/4" or 25/32" wide by 3/8" height. by chance have anything like this. Thank you

The first two pictures are one seal. The second two are the other seal.

Do you have replacement rubber weather stripping that fits at bottom of window against sill. It is black and fits in a channel. CGI model SH4000/SH4001

Could you tell me how I can purchase weatherstipping for a guardian manufactured sliding glass door...as you can see by the attached photos it definitely is in need of replacement. Thank you...greatly apppreciatedBarb

I need to replace the bottom weather seal. I believe it is made by Ply GEM, I have parts list. Can you determine which part # it is. And if it can be replaced with a new piece. Thank you George

I have attached some photos of old bubble seal taken from an older Marvin awning window that was installed when we built our house in 1988. I'm trying to find replacement bubble seal because, as you can see, the existing is old and falling apart. Any ideas on what product would work as a replaceme ... (cont.)

do u have weather stripping for anderson casement windows i would like to buy a roll of 100 ft i have over 20 windows

I can't seem to find this. 1/4 x 3/4

Can you please identify the weather strip for this Pella door 90s era and direct me to a replacement part as well as instructions to perform the replacement?