Viewing all customer Discussions for:

Weatherization

I measure L tip to be 1/4 inch. Length of strip is 34 inches

Trying to locate i have pictures

I'm searching for replacement seal/weatherstrip for my late 80s/early 90s Weather Shield casement windows. The outer seal appears to be a bubble seal (like 58-053?) and the inner looks like a bulb strip (similar to 58-173?). Do you have any recommendations on replacement parts?

this is a St. cloud windows sliding door gasket. need something like if not the same one. Thank you,

My exterior window seal is rotted and I need to replace i

Looking to replace damaged weatherstripping for certainteed windows installed approximately 1995.Pictures attached. I can send measurements if you have this type available.ThxJoe

Looking for this seal. It has a T shaped part that slides into the channel. The seal is foam filled vinyl covered. It is similar to your 58-200 seal except that the mount is T shaped and not kerf. The T measures 3/16".

Weather stripping for a door

Hello,I need help getting this Aluminart Door retainer strip. Can you help?Scott

I have SIMONTON double hung windows.I have attached the photo for your information.Provide part number for Fin Seal weatherstripping.ThanksRamanlal

My weather strip came out again, we glued in last time and this time , a year later, it came out. How do you suggest we repair ?

I am looking for sash seal for my casement windows. The manufacturer of the windows is Scherer Brothers Lumber of Minneapolis MN. Thank you. Bulb height about 0.300. Width about 0.626 kerf depth 0.26

The felt and rubber that goes in between the two commercial doors, the vertical stripping

I'm looking for the exterior weather stripping for my casement window. I am unable to identify the type of window. It looks like kerf weatherstrip. It sits on the outside edge of the case when window. The weather stripping is falling apart.

I have 3 6'X6'8" glass sliding doors ~22 years old and need to replace all weatherstrip. I am not opposed to modifying stops etc. to accommodate another brand/style. Have found similar on other sites, but can't afford $500+/door. I've appreciated your help in the past. Thanks Retired builder, Da ... (cont.)

I'm looking for a FLAT SPLINE WITH A FLANGE, which goes at the Non-Opening vertical edge of my glass patio door which opens. If I'm USING THE WRONG TERM FOR THIS WEATHER/CRITTER MATERIAL, PLEASE TELL ME THE CORRECT TERM, SO THAT I MIGHT FIND IT. This is probably from the late 1970s into the 2000s, ... (cont.)

Need patio slider vertical strip

I am looking for a new seal for this door. It's a pella. Not sure if the markings on the glass would help.

The plastic base is 1/4 inch wide and the pile also is 1/4 inch tall, including the base.

I am looking for replacement weatherseal that came out of a caradco casement windows installed in 1992. Measures 1/2 inch wide. The side that inserts into the window slot is 3/16 to 1/4 inch deep.