Viewing all customer Discussions for:

Weatherization

I'm a new home owner. I have an aluminum sliding glass door that I'm looking to replace the pile weatherstrip as well as whatever insert is at the top and bottom of the doors. I can't tell what the material is/was at the top or bottom-- I don't think this has been changed in at least 25 years. I hav ... (cont.)

Could you please help me identify this profile? The straight parts are 3/8" and the longest measurement is 5/8". Almost looks like a 90 degree when it is in place in the window frame

Hi, we are looking for the rubber or vinyl seal shown in these pictures. Do you have this part? Window slot is about 3/32", bulb is 1/4" OD, looks like barbed? but real worn out, maybe kerf?, for old aluminum tilt balance windows. The tilt balances and latches (26-295) I purchased on previous orde ... (cont.)

Hello I am trying to find weather stripping to match this for an exterior door. Thank you, Kyle

Good afternoon; I need door seal for 3 sets of double door, I can not find a name on them, each door has 2 seals, 7 ft long. The felt measures 1/2" and the base is 1/8" Please let me know if you need any additional photos or information from me.Thank you Stan

I need three replacement door sweeps. Let me know what additional information you need. Thank you, Rob

A little flap of rubber that go's on the inside of the bottom of the top window. it fits in a 3/16 groove. It helps block air from blowing up between the two windows. i cant find it on your site, can you tell me what i need? thank you

I am looking for replacement bottom door seals as noted in the photos. One seal is a type of wiper seal on the bottom of the door and the other seal is a bulb seal (~1/2")bulb diameter. Third photo shows the door serial number Thanks. Mike

Stanley door 6 panel steel entry door. Model 07303. I have replaced the side and top seals easily. The bottom seal seems different. I can't seem to remove it without ruining it. It needs to be replaced and I can't find the part that seems to be the same. Help.

this is a rubber rain guard at the outside of the bottom window sash

In need of replacing this weatherstripping, however not sure which one should I be purchasing. Can you please help?

Hi, I am trying to replace the seals on my aluminum sliding windows (unknown brand) they are a kerf type seal. The width of the seal overall is approx. 1.5 cm (5/8"). THe widthe of the portion that goes in the kerf slot is approximately .5 cm (1/4"), the depth of the rubber going into the kerf slo ... (cont.)

Hello, I am having trouble accurately measuring my bubble seal and pile parts. First the bubble seal t slot is very close to your .187 width, BUT the hollow bubble appears to be about .4 inches, not .3 that you sell. Second, the pile weatherseal has a base of about 3/16 inches like your number58-02 ... (cont.)

It is off windows that crank open from inside. There is 2 rows of these on each window. Appears to have a peel / stick backing

Attached picture shows piece of seal from existing window. Looking to replace this seal in a couple windows. Do you have a matching replacement?

Looking to replace, is the outside of the window bottom they were soft vile or rubber they are now brittle and cracking and I don't know what they're called a sash seal Maybe

I am trying to find weatherstripping for my older casement windows. I believe it is a .250 bulb with a 90 degree kerf. Would you be able to help?

The bottom strip on my door wall came out. Looking to replace it

Glazing bead for sliding aluminum window

Hi Trying to replace the door sweeps on my two porch doors. Do you carry this item ?