Viewing all customer Discussions for:

Weatherization

Was trying to figure out what part I would need to replace this weather seal. Window manufacturer is United

looks like vinyl/plastic weather seal on an older casement window, aluminum clad wood construction, approximately 40 years old?

I need 6 ft of replacement bubble weatherstripping, matching the dimensions of the picture attached.

Hi, I'm having trouble finding this weather seal. I believe the windows are builders grade when the house was built in 1999. Any advice is greatly appreciated. Thank you!

Hello, we are looking for a window seal that will work with our Mitchell replacement windows from 2005 and slides into the front side of the window. Thank you

This is the bottom seal on my aluminum widows (see photos). The windows were installed when the home was built in 2001. appears to be a 1/4 bulb and approx 1/8 inch (3mm) kerf. looking for replacement seals.

Have 6 windows seal area approx 22x56. Have not evaluated all seal to see what needs replaced. Do you have this style of bubble seal?

We would like to replace all of the weather seals on the Jeldwen door in the attached photo. Thank you.KimKNC Contracting

Looking for an astragal weatherstripping similar to 58-085 but with a pile projection of 1/2"

83" length Need to order weather stripping for this door. Weather stripping is only on one door ; other is without weather strip channel Its just an open channel through and through. Nothing at bottom or top.

Looking to replace this glazing bead . Can you help find it thank you

I'm a new home owner. I have an aluminum sliding glass door that I'm looking to replace the pile weatherstrip as well as whatever insert is at the top and bottom of the doors. I can't tell what the material is/was at the top or bottom-- I don't think this has been changed in at least 25 years. I hav ... (cont.)

Could you please help me identify this profile? The straight parts are 3/8" and the longest measurement is 5/8". Almost looks like a 90 degree when it is in place in the window frame

Hi, we are looking for the rubber or vinyl seal shown in these pictures. Do you have this part? Window slot is about 3/32", bulb is 1/4" OD, looks like barbed? but real worn out, maybe kerf?, for old aluminum tilt balance windows. The tilt balances and latches (26-295) I purchased on previous orde ... (cont.)

Hello I am trying to find weather stripping to match this for an exterior door. Thank you, Kyle

Good afternoon; I need door seal for 3 sets of double door, I can not find a name on them, each door has 2 seals, 7 ft long. The felt measures 1/2" and the base is 1/8" Please let me know if you need any additional photos or information from me.Thank you Stan

I need three replacement door sweeps. Let me know what additional information you need. Thank you, Rob

A little flap of rubber that go's on the inside of the bottom of the top window. it fits in a 3/16 groove. It helps block air from blowing up between the two windows. i cant find it on your site, can you tell me what i need? thank you

I am looking for replacement bottom door seals as noted in the photos. One seal is a type of wiper seal on the bottom of the door and the other seal is a bulb seal (~1/2")bulb diameter. Third photo shows the door serial number Thanks. Mike

Stanley door 6 panel steel entry door. Model 07303. I have replaced the side and top seals easily. The bottom seal seems different. I can't seem to remove it without ruining it. It needs to be replaced and I can't find the part that seems to be the same. Help.