Viewing all customer Discussions for:

39-121 Crank Handle, 3-1/8"

1972 Champions mobile home , with this style side crank out window , I have tried some jalouse brand cranks . But they don't close the widow all the way tight . They look the same but the widow stays open a inch ( the gear on the crank stops dead ) I don't want keep buying trial and error to see if ... (cont.)

I'm looking for the handles that you turn to open your windows in your RV or camper I just purchased a new one and I pretty much don't have any of them except for this one on one window I need the part number or where I could find them I have not been able to find them in I am looking for them or to ... (cont.)

Is the screw included with the handle as I need both thanks

Looking for that window opener please see attached and the handle that works with it.

Do you have this replacement part or something similar? The handle broke off the crank part.

We need replacement cranking handles with extended handles.3.5 -4 in Thanks

I have some older louvered style windows in a shed that I need to find replacement crank handles for and possibly the geared operator that the handles attach to for some of the windows. I measured the splined shaft that the handle attaches to and it looks to be very close to 5/16 diameter. It also ... (cont.)

No markings or numbers is 2" by 1/14"

Looking for pricing on crank arm parts and/ or entire crank unit. Pictures attached.Thank you, RobbinPLEASE DO NOT SELL ME EMAIL ADDRESS to others for promotional purposes.

I would like an end view of the aluminum crank with good lighting to see what the spline teeth look like to see it they are grooved deep enough to work over a long period of time the plastic ones have very little teeth and over time the plastic will dry rot.

On the 39-234 operator, how long is the operating handle on the gearbox and how far does the torque bar fitting extend from the gearbox also? Thanks for any info, I'm trying to replace a unit that only has the numbers 887106 on it.

The crank/handle is plastic through and through which is probably why it simply wore out. It is 3 1/4" long. The outside diameter is 14/32". The inside diameter is 10/32". KINRO is written on it. It belongs to a window in my shed.

Will 39-357 fit the Milgard Tuscany casement window. I'd like to extend the crank 6-10 inches. Will I be able to attach two 39-357 extensions together along with 39-121 Crank Handle?

I have ordered an extension handle and a crank handle. Since there is no set screw on the handle extension I would need to have a screw roughly 5 1/8 long to secure both. What is the screw diameter?

Do you have any with a 7/16 spline

Is the 39-121 crank handle made out of aluminum or what type of material? Thank you, Tom