Viewing all customer Discussions for:

58-085 7' Commercial Door Weatherstrip

Hello, I'm looking to get a price on replacing this door nosing weatherstrip. I would like the black portion and the fuzzy weatherstrip.

Commercial aluminum storefront door felt weatherstripping 1/2" x 11/16"

We need weather stripping for an 8' exterior commercial door

Didn't find any numbers or markings on the weatherstripping or the door

I had purchased the 58-075 but it was too small mine needs to be wider around 2 1/2 in wide and 7ft long hopefully you have the option for me

I am having trouble locating this Astragal. You can see it has the adjustment screws off to the side. The brush pile strip seems to be smaller than the average CRL .187 so finding the replacement brush pile is tough. Can you direct me as to where to find this type of Astragal. On the back side there ... (cont.)

I need this weather stripping between my commercial doors an I also would like to know is there a way to install a weather stripping on the opposite door

I took pictures of the weather stripping from all sides hope that helps.The stripping is made of aluminum with spring clips on the back screws hold it on. The brush needs to be longer to seal against the other door I think.again thank you for your time.

I'm looking for the weather strip between the doors which is 1/4" thick and 5/8" wide. Also need the sweeps on the bottom of both doors. Thanks. Brent

I am trying to locate replacement rubber seals for the bottom of an EFCO door. It appears to be similar to a windshield wiper and slides in from the end (see photo). Thank you, Matt

Need to purchase replacement weatherstripping. See attached photos. Thanks!

I am looking for 14 feet of this product. It looks like it is 7/16".

Looking for replacement for this pile weatherstrip. It seats into the edge of the door rather than sliding in from the ends. I have 4 doors, 94" each door. Thank you!

I need to order replacement weather strips for a store front doors and can't find a manufacturer name on the doors and they are two different styles I need to replace

I need the pile weaather stripping piece shown for a typical commercial door, let me know if I missed anything, I will need to drll my own holes in it for the mounting screws. Let me know if you need anything else

Hi, I found a 7' commercial door weatherstrip on your site but I wanted to make sure this would be the right fit for my machine. Also is there a part I can use for the weatherstrip on the lock faceplate and the bottom of the door

I would like to replace the door seal. I'm not sure if the wool seal has an adhesive that sticks to the metal part. This section was at the top of the door that I unscrewed and slid out of the T-slot. I'm a volunteer for my church where this is located.

Hello I need weatherstripping for this commercial door including the piece around the latch. Is this something you can help me with? Top piece is 31 1/4" and bottom is 45" plus the assembly around the latch. Thanks!

THIS SEAL SLIDES ON FROM TOP GROVE GOES OVER SCREWS AND IS HELD IN WITH A ROLL PIN TO KEEP FROM SLIDING OUT OF GROVE

Looking for a kawneer commercial door astragal