Viewing all customer Discussions for:

70-140 Stainless Steel Z Clip, 7/16"

Hi Do you have anything like this to hold in storms and screens. From 1960 Kaiser Aluminum.

Greetings,I have a glass-enclosed sunroom that has screens. The screens are held in place on the left and right sides by plastic retention holders that are simply riveted into the window frame. Over time, the plastic has become brittle and is cracking therefore not doing a good job of holding the sc ... (cont.)

Dear sir/madam, My name is Volker and I am the director of operations at Strassburger Window and Doors located in Kitchener, Ontario, Canada. We manufacture windows and entry door systems. We have a requirement for a tilt and turn window screen retention clip. I have attached a drawing of the part w ... (cont.)

The window screens have two of these clips on one end. The other end has two tension clips. Looking for the clips in the picture.

5/16 inches wide...section with hole is 9/32" long, center section is 9/32" long, small section with slight bend at bottom is 7/32"

Plastic screen/storm door window clip to hold either screen door or glass insert.

Hi, I am looking at your 70-140 stainless steel clip and notice it only comes in a 3/8" width. I am curious if you make this same part but in a wider 1" width. Thank you for your time.

LOOKING FOR REPLACEMENT STORM DOOR CLIPS, CANNOT FIND ANY MODEL NUMBERS OR BRAND NAME ON THE DOOR. THE CLIPS ARE SELF-LOCKING ALUMINUM OFFSET. THEY MEASURE 5/8 WIDE, 3/4"LONG (WHERE THE THUMB SCREW GOES INTO), THEN 1/4" LONG 90' BEND, THEN 3/8" LONG RETURN BEND THAT GOES AGAINST THE GLASS DOOR P ... (cont.)