Viewing all customer Discussions for:

70-180 Storm Door Insert Clip

I have this retainer strip that I would like to replace. I have no idea as to the make of the storm door. I saw this post dated November 29, 2016 and believe it to be the same as I have. At that time you recommended going to storm clip 70-180. The problem is the offset from the door to the windo ... (cont.)

Do you have clips that you could recommend to hold three 9 inch by 22 inch stained glass panel in a front door sidelight window. The three windows would be stacked vertically. The total size of the sidelight is 9 inches wide by 66 inches high. Thank you! Kim

Older metal storm door. At the bottom third there's a metal panel that is retained with these plastic strips. The strip is 1/2" wide but I don't know the thickness, maybe 1/8" or less. There are a couple ridges that help it grip the channel it sits in. Pictures are of the strip pulled from its chann ... (cont.)

Looking to replace the Retainer for my Cole Sewell Storm Door Estate Series. The door is either a 4000 or 4500 model, but I can't tell. The registration number is ES 440389 if that helps. I am hoping the part is the same for both. How can I acquire this part?

I have no name or markings on this storm door. but here is the pictures of what I need

We are looking for replacement screen retainer strips for our storm door. I've added pictures of the end of the strip. The strips are 62.5" long and are made of plastic. Do you carry anything similar to this?

I have an Emco storm door with an identifying number of 0016068933. I need the pieces (4) that hold the screen or window in place. The door has either all glass or all screen. I'm guessing the door is around 10 years old & was likely purchased at Lowe's or Home Depot.

I just bought a house that has tilt windows. A lot of the plastic screen "retainers" are cracked. The window screen says Century Windows with numbers 34457 006 bedrooms and 34457 005 kitchen. Do you have anything like these? (I'm not sure if I'm describing them properly so I'm attaching a few pict ... (cont.)

I need a replacement for these clips to hold the window in place.

I am looking for 8 plastic clips used to hold a screen in place. I am trying to replace screens in two windows.

I have no MFG part numbers

Hello, I need 50 pieces of this screen retention clip. The screen is pushed up into a slot in the vinyl and then rubs against this piece which is in the bottom slot the window. The piece is made of whit vinyl and some of them wave rotted in the sunlight. As you can see from the ruler comparison, ... (cont.)

Do you have anything like this. It clips over a screen and on to a metal frame on a front door at Century Village Boca Raton Fl.. Sorry, I don't have a picture of the door.

Can't find replacement anywhere

Hoping to get a replacement piece for my front door retainer strip. Can you help?

1/2 " deep

Hello, I have a customer who needs these clips to replace broken or missing ones. They seem to be the window screen retainer clips that snap into the aluminum screen channel. I've been looking online for about 45 minutes and cannot locate anything even remotely similar. Any chance Swisco carries ... (cont.)

These clips hold a PPG Hurclulit tempered glass into my storm door. I am unable to find ones long enough to replace

Glass retainer

Storm door interchangeable glass or screen is held in by 2 vinyl (??) strips along the frame sides, approx 73.5" long each side. You just press strips in and pry them out to install or remove them. Current pieces for the home we just bought are old and too brittle to be used much longer. Do not s ... (cont.)