Viewing all customer Discussions for:

81-005 Sliding Door Roller, 1-1/4" Steel BB Concave Wheel

Looking for mid-80s roller assembly that is marked Allen Stevens Corp Woodside, NY. Roller appears to be 1-1/4".

It has two tabs on each side that latch it into the track part under the door

Need to replace broken parts

I can please help me replace this.And the other one. Tx

1980's patio door

Looking to replace some rollers on what we are told is a "Moss" brand door. Did not see aything like it on your list of patio rollers. Photos include measuring tape for review. Any help is appreciated.

It looks closest to your 81005 but it's slightly different where the unit screws into the frame. The label on the frame door says series 100/150

I have quite a few of these 8' sliding doors and each door has 2 rollers. I'm guessing they all need to be replaced. Probably 16 doors total. 32 rollers. I'll get an exact count next time I'm there. I'm the homeowner, also an architect and contractor.

Seems to be an Allen Stevens Corp roller

Allen Stevens Corp. Woodside, NY and in a circle pattern 60 with 49 under it

Part 8314 single roller, 11/16 x 2 inches by 1 1/8 tall

Markings are Allen Stevens Corp. Woodside NY. With numbers 83 and 14 underneath the 83

Aluminum slider, older model with no brand name. Looking for replacement wheels. Carriage and wheel are steel. Wheel is concave. You have to disassemble frame and wheel carriage slides in from end. There are two rectangular divot holes to hold it in place. Wheel is around 1/4" wide and about 1 1/4" ... (cont.)

I can't seem to find this one in your selection online. I figured the logo on the side would be a dead giveaway.

The existing rollers as shown in the photos say "Allen Stevens Corp Woodside NY". These look like the 81-005 item found on your website can anyone confirm? We have 4 doors so 8 total rollers needed. Thank you!

Hello, Do you happen to have a replacement for this roller? I will need two of them. Thank you, Fernando

Did not measure so I am unsure of the dimensions.

My tech only took 2 measurements, is this enough to find a match?

Hi there, For the life of me I can't figure out how to replace the rollers on this door. There's a brush strip on either side of the inside where the wheel sits, and even when I unscrew the bottom screw, I can't pry the cartridge out because I can't see the sides of the cartridge. Is there a cartri ... (cont.)