Viewing all customer Discussions for:

81-030 Acorn Patio Sliding Glass Door Roller, 1-1/4"

I am needing 2 tandem rollers for my patio door...can u help me make sure that I am getting the correct part...thank youPaul

Please help me identify the attached rollers (or compatible replacements). They came out of an SGD-R20-96x82 sliding door, probably installed in the early 2000s. Unfortunately I was not able to get a picture of them installed, but they install by only one screw (pictured). Thank you for your help. ... (cont.)

Steel wheels 1 1/8" dia housing is 3/4" thick and 1-1/8"H, 3-1/8" W has a V stamped on one side and nothing any where else in lettering

On part 81-030, is the 1 1/4 inch dimension in the picture for the outside diameter or inside diameter (bearing surface) of the wheel? If it's the inside diameter it's the part I need. The assembly I need to replace has 1 1/2 inch outside diameter wheels. Thank you!

Door is 71x80

Dimensions of door roller: 3-1/8" long, 3/4" thick. 1-1/8" tall, 1-1/8" diameter wheels "V" stamped into body.

Good morning, My name is Joseph. I'm looking to get this roller if you can identify it and have it in stock. If you could please take a look at the pictures and see if you have this one in stock, I definitely would like to get the replacements. Thank you and I look forward to hearing back from you ... (cont.)

Good morning, The rollers on our door need to be replaced, can you please identify these? Thank you so much.

Really not able to find any markings on roller assembly or the door

I need the two rollers for my Reliabilt Vinyl Sliding Patio Door. The size is 72 x 80. I also need the track. The track is aluminum 1 5/8 width and the track is on the middle of the aluminum plate.

Mortise lock and metal gliders

Need Help Identifying Replacement Roller - Roller has Stamp "DISCO 2192"

Need two replacements

I need help to figure out what wheels I need for my sliding glass door. They have broke off.

I believe this is a Anderson sliding door. Rollers seem stuck and can't be adjusted.

My door uses a double metal wheel assembly. The height is 1 1/8", width is 5/8", with a roller diameter of 1 1/2". When installed, there are two access holes from each side of the door. The upper screw holds the roller assembly to the door and the lower is an access hole for the height adjustment of ... (cont.)

I am trying to identify the right part. I suspect that you 81-030 "Acorn" would work fine. I see the roller diameter is different, but I believe the height adjustment would allow compensation for that difference.

Can't find any markings. GC says it's a shwinco door. One set is completely wasted. Would like to replace both sets for this door

I need to purchase some rollers

please id the rollers in the uploaded files