Viewing all customer Discussions for:

81-112 Peachtree Patio Door Roller Assembly

I've been attempting to find a replacement for these and have had no luck. I purchased the closest I could find and it was still incorrect. Please assist

I recently replaced the rollers (81-112) on my sliding glass door. I seems like the wheel bearings are sticking or something? The door is very hard to close. Is it possible to grease those bearings? I have used the wax on the bottom rail & that isn't helping. What am I missing?

Please help be me find this patio door roller Thanks

The door has a tag that says "Citation"

7/8" thick 1 1/4" metal wheel 2 3/16" long 1 9/16" tall

Hello, I am Kyle Enslow. I would like some help in selecting the correct Sliding Door Wheel Assembly. Please see dimensions below: Assembly Width - 7/8" Assembly Length (W/o tabs) - 2 1/4" Wheel Width Inside - 1/4" Wheel O.D. - 1 1/4" Thanks!!

Needing to replace two all metal rollers for sliding door. Door may have been installed in the 1970's. Photos attached. Thanks for you help, Matt

Patio doors very old about 40 years old there are no markings or numbers on the old roller parts.

Sorry I cannot find any label on the door to provide you with the name of the manufacturer.

I would like to get the two patio door rollers identified/replaced. Please let me know what additional information you might need. Thank you for your help and I look forward to hearing from you. Richard

Please help to find a replacement

Need replacement roller for 45 yr old Peachtree door. Bearing is shot and roller gets jammed.Are these photos adequate to identify the replacement Swisco part. Thank you for your assistance. Buster. I will replace two rollers.

My sliding doors are at least 40 years old and unless I remove the doors there is no way I can determine what roller to buy. You list both 81-112 and 81-036 and maybe another. Is it possible to determine which one was used in the late 70's or early 80's?

Home built in 1985. It looks like peach tree but you decide Need 8 of these

This part is 2 3/4" (L) X 1 1/2" (H) X 7/8" (W). Please get back to me for an order of 16 of these. Thank you. Need 8 sets of these.

Looking for this part for my sliding patio door.

THE DOOR WAS INSTALLED IN 1976, and made by ATLANTA DOOR CO. WE BELIEVE

I could see no apparent screw attaching roller body to rail; it appears to be held in place by the corrugations machined into the stile (these are visible in the photo). Since the door is dual-glazed 6-0 x 6-8, the 3-0 sliding panel is heavy enough to warrant a pair of dual rollers. I'd like an opt ... (cont.)

Single wheel almost an inch wide and 2 3/4 long. Aluminum frame door from probably about 1980.

in pic #1 notice the 1/8" tab rising above the main body on right side height. this acts as a stop. The assembly slides into the frame until the tab butts up to the frame.in pic #4 you can see the assembly has to be open on top to clear the screw channel on the frame.I appreciate any help you can gi ... (cont.)