Viewing all customer Discussions for:

95-214 Screen Door Corner

1. Screen door corner piece 2. Clip to attach horizontal trim piece at the top of the window blind 3. Do you sell tip out trays for a kitchen sink front?

hello IHello I am looking for replacement braces. Those slip inside aluminum extrusion the same way smaller ones slip into screen frames. But this is an entry screen door or storm door.

These look like 95-214

wanted to make sure I was ordering the correct piece for our gazebo screen - all 4 corner joints are broken and we need to replace them and then the screen. Pictured is half of one broken joint. Thank You!

Slideing glass door screen door

Hello again. Thank you for all of the assistance and support the Swisco Team has provided thus far. Attached you will find photos of screen door corners which have become brittle, broken and need replacing. The width of the door frame appears to be 3/8"; the pictures provide additional ... (cont.)

I'm trying to find a replacements parts for : Andersen PL16124 1" x 15/32" White Plastic Screen Door Frame Corner. Also, Anderson Rollers for a screen door repair. I would need (4 of each) Thank You,

I bought the 90-214 screen door corner. These pieces are too large for the screen door I have. It needs to be 1" x 1" x 3/8" thick.

JeldWen screens

Hello. I hope you can help locating this part. The dimensions are 3 1/2 inches at it longest including the piece that extends out at the corner. If you do not include that it measures 3 1/4 inches in length. It is 1/4 inch or 7/16? of an inch thick at the point of where it gets inserted. the pie ... (cont.)

Dear Swisco,I need 4 new corners for a sliding screen door. The corners are white plastic, 1 inch wide, 1/2 thick. and measure 3 inches from end to collar. I can't get the other end out as the plastic is decayed and the other corners all broke in half. The other side should look the same as this sid ... (cont.)

Need Help Finding these corner keys. There are pictures attached. I need them in tan if possible. Dimensions are: 1" wide x 3 1/8" long x 7/16" thick.I believe I found an old part # of 10-39617 if that helps. Thanks, Gil

width = 7/16" length side = 3&1/8" depth =1&1/16" corner rectangle = 1/4" I hope the picture is sufficient . my measurements are based on a tape measure. hopefully it is precise enough. Thanks for your help. What a terrific service this is.

3/8 or 1/2 wide x 3 1/2 long outside tip to tip I found Code# 95-214 that looks close, but not sure?

Took our screen door to our local Ace to have it repaired. They didn't have the parts. This has now turned into a DIY project.

I need theses parts, four each

need replacement screen frame

Hard to explain. No markings. A picture is worth a thousand words.

Its the connector in each of the four corners, its around one inch wide by apprx 1/2 inch deep

Where can I order these