Viewing all customer Discussions for:

10-126 Chrome Finish Shower Door Handle Set, 2"

I am looking for two replacement shower door handles with towel bar inserts, as shown in the attached pictures. The distance between the center of the two holes is 2 inches. The only marking I see on the handle is N.A.81 4 I. The towel bar insert measures 15/16" by 6/16". I see you have one that ... (cont.)

L121-1A is stamped inside. It looks like brushed nickel. Screws are 2 inch spread. Where can I find a replacement part for this handle? Thanks.

Almost two years ago, we bought some rollers for the top of sliding glass doors on my tub. Now, I need to get handles for them. BUT, I don't see anything like that on your website. Do you carry anything like this?

This insert connects to a handle in the other side of the door, do you have the handle also?

Hi, I have checked the length from centre of both the holes and it is exactly 2 inches. Can you suggest if we can get the same piece for 2 inch length. If not - what could be my option - can you please suggest. There are holes in the glass door with 2 inch spacing on both sides. Regards, Man ... (cont.)

I ordered a 10-126 shower door handle to replace the broken one on my shower door but the holes for the mounting screws don't line up it appears that this handle is a bit smaller. how do I determine the exact size I will need and then how to I go about exchanging this one I just purchased. Thank Y ... (cont.)

I'm purchasing "Door Handle With Towel Bar Insert, 2-1/16" (10-138)" to replace my broken ones (very hard water!) On my particular shower doors however, there was an inside handle AND an 'outside handle' which I can't seem to find. The difference being, the 'outside handle didn't have the towel ba ... (cont.)

Replacing broken handles on a two sliding panel shower. Original handles had a towel bar, which is now out of style. So replacing with simple handles. The 10-126 looks to work to replace on the outer side frames. (My door appears to be 1/2" width, so hope that is not an issue) Any product t ... (cont.)

Do you have a 10-126 on 3 5/8 centers instead of 2 inch?

Do you folks offer these handles in 2". I found product #10-138 but those are 2 1/16 on center. Also do they come with the mating handle for the other side.

What is either the diameter of the threaded studs or of the hole required for them (10-126).

Hello, Does the 10-126 come with the mounting screws? Your description does not indicate screws are included. Thanks, Gregg