Viewing all customer Discussions for:

23-010 Rear Closet Door Roller, 1/2" offset

I mave have two pictures of same roller but need part identification to order multiple pairs for roller doors and some floor guides

Need a matching pair. Roller is approx 3/4" Offset 1/2"??

I am looking for a replacement (8 hangers total) for a broken bypass closet door hanger. Only one broken but will replace all four doors since the hangers are all about the same age. The hangers are mounted on the back of the doors. The image below has measurements and shape. Stamped 3/4" FRONT and ... (cont.)

National mfg co

1 3/8 front 3/4 rear W 671 USA I try to search but not sure if there's still parts like this, came from closet door sliding. I need 1 pair. Thank you!

Hi, We have bypass sliding doors from the 1950s/1960s. The rollers have become worn and the doors are difficult to move. The pictures are from the back door since it has been sticking the most. The doors are 1-3/8" thick and are hollow. The front door has different hardware but still seems to be ... (cont.)

Good Afternoon, I need to replace 4 of the assemblies in the picture for two wood bipass doors. Home was built in 1958. The info on the part is: Standard-Keil 81 - 1 1 3/8. Thank you!

Grant Rocket 3/4 Front 1-3/8 Rear Grant Rocket 1-3/8 Front 3/4 Rear

I am in a house that was built in the fifties. It has closet doors using your parts. The doors are hanging up. I haven't been able to find replacements. I am attaching pictures of the rollers and track.

It appears you might have this part It is from a 1960 built home for sliding closet doors Hope U can help me Phil

Good morning, we are looking to purchase the closet door guide in the image attached. please let me know if you carry this or something comparable. thank you in advance.

I am needing to replace a few of these in an older home and I don't really want to re install all new tracks. The plastic roller has broken and I tried to pop out the rivet and replace it with a tub roller but that was off by 1/8" and made the doors rub. The markings on the hardware says GRANT ROC ... (cont.)

Good morning, Our home is older and the hardware for the doors have been very hard to find. Can you please assist in letting me know what replacement hardware needs to be? I have attached a picture of what the hardware looks like. The information that is on the hardware is as follows: 3/4 F ... (cont.)

3/4 INCH DIA ROLLER ON A 1 3/8" THICK BYPASS CLOSET DOORS.

I have rear closet door roller and the size length is 1-3/8" and the rollers size is 3/4 ".I want know can I go with a different size rear closet door roller like the one u have shown #23-010, Andrew C.

An image is posted above. We need 9 sets of these rear by-pass hangers for our Bifold doors. We have 9 doors all together. Each door base 2 of these hangers with a wheel on it. We just can't figure out what exact part we need. Hope the photo helps. Jeanne

The posted photo from a 1970's house. All double doors. Offset looks like 3/8", length 2-1/2", roller dia 3/4". Marked "Kennatrack" and has a capital "B" with a circle around it. Can you help with a replacement part? I guess the alternative is to get a new track and roller set.

I found the 1/4" and 1/2" offset. Do you have a 1" offset??

SWISCO was unable to locate a 1" offset for this style closet door roller.